QP Series Model QP-5 Parts Manual This manual contains important safety information and must be carefully read in its entirety and understood prior to installation by all personnel who install, operate and/or maintain this product. On-line product registration, parts ordering and warranty information is available at www.quincycompressor.com Manual No.
Table of Contents IntroduCtIon This manual provides information for the Model QP-5 reciprocating compressor. Serial Number Identification...................................2 Ordering Replacement Parts..................................2 The Model QP-5 is an aircooled, two stage, two cylinder, pressure lubricated compressor, with up to 175 PSI continuous pressure capability. It has a 4" low pressure bore and a 2.25" high pressure bore, with a 3" stroke. This compressor can be run at 400-1060 RPM.
Serial Number Identification Quin-Cip lubricant Refer to the chart below to order Quin-Cip-D or QuinCip compressor lubricant from your local authorized Quincy distributor. The unit serial number identification tag is located on the air tank top plate. The basic compressor serial number decal is located on the side of the crankcase opposite the oil fill side.
Crankshaft Group 113684-009 QP-5 2022201301, July 2014 Quincy Compressor 3
2022201301, July 2014 1 1 2 qt. 110377E100 air filter element 2023400100 oil filter 115468Q Quin-Cip-D synthetic lubricant Item Part # Qty.
Connecting Rod & Piston Group 113686-002 (low pressure) Sterling Blue Ring Kit 2022104400 Item Part Qty. Number Description # 1 1 1 2 2 114097-002 111199 111200 111105-001 111105-002 gasket set piston ring set piston ring set piston pin plug piston pin plug Overhaul Kit 2022100900 Item Part # Qty.
Connecting Rod & Piston Group 113687-002 (high pressure) QP-5 2022201301, July 2014 Quincy Compressor 6
QP-5 2022201301, July 2014 7 1 1 110258B060 drive belt 114096-002 valve assembly repair kit Item Part # Qty.
QP-5 2022201301, July 2014 8 1 1 1 1 1 1 6 6 1 113618-002 113618-003 113617 113943 113755 111106-001 114440-L22 114595N038 50278-101 gasket, valve plate to head gasket, valve plate to head gasket, cylinder to valve plate gasket, crankcase to cylinder gasket, bearing carrier oil seal hex. screw, 3/8-16 uc x 3.525 flatwasher, 3/8 head bolt torque instructions Item Part # Qty.
Control Piping Schematics QP-5 2022201301, July 2014 Quincy Compressor 9
Pilot Valves 113708 Series Pilot Valve (continuous run operation) 110998 Series Pilot Valve (dual control operation) Add dash # listed below to 113708 (per pressure setting) to obtain correct pilot valve. Add dash # listed below to 110998 (per pressure setting) to obtain correct pilot valve.
Suction Valve Unloader Assemblies Installation The pilot valve is mounted directly into the air tank. Compressors in the field, not equipped with these controls, can be converted. Consult your local Quincy distributor for assistance with conversion procedures.
Typical Unit Repair Parts List The parts listed here are for standard QP-5 (up to 175 PSI) units and may or may not be applicable to custom built units. Check with your local authorized Quincy distributor for parts that can be used for custom built units. Make sure the components you order are rated within the safe operating limits of your system. If you are doubtful about which components to order, contact your local Quincy distributor.
Typical Unit Repair Parts List The parts listed here are for standard QP-5 (up to 175 PSI) units and may or may not be applicable to custom built units. Check with your local authorized Quincy distributor for parts that can be used for custom built units. Make sure the components you order are rated within the safe operating limits of your system. If you are doubtful about which components to order, contact your local Quincy distributor.
Typical Unit Repair Parts List The parts listed here are for standard QP-5 (up to 175 PSI) units and may or may not be applicable to custom built units. Check with your local authorized Quincy distributor for parts that can be used for custom built units. Make sure the components you order are rated within the safe operating limits of your system. If you are doubtful about which components to order, contact your local Quincy distributor.
QUINCY COMPRESSOR STANDARD TERMS AND CONDITIONS LEGAL EFFECT: Except as expressly otherwise agreed to in writing by an authorized representative of Seller, the following terms and conditions shall apply to and form a part of this order and any additional and/or different terms of Buyer’s purchase order or other form of acceptance are rejected in advance and shall not become a part of this order.
Reciprocating / Systems: E-mail: Website: 251.239.5900 info@quincycompressor.com quincycompressor.
