QP 7.5 Part Manual

ManualsBrandsQuincy ManualsStationaryQP Pro 7.5-HP 80-Gallon Pressure Lubricated Two-Stage Air Compressor (230V 3-Phase)

Table Of Contents

Blank Page

QP-7.5 Quincy Compressor

TYPICAL UNIT REPAIR PARTS LIST

(QP-7.5 simplex - horizontal tank - electric motor)

Part Part Part

Qty Number Number Number Description

80 gal. 120 gal.

1 113268P200 113271P200 tank (200 PSI maximum operating pressure)

1 2713 111136-050 tank drain valve

1 111136-075 111136-100 service valve

1 110514-300 110514-300 pressure gauge

1 110512-005 110512-005 pressure switch

1 110513-200 110513-200 pressure relief valve (in tank; 200 PSI)

1 111089-215 111089-215 pressure relief valve (in discharge line; 215 PSI)

1 111491 111491 check valve

1 114559-001 114559-001 discharge tube

2 110948-075 110948-075 tube ﬁtting, nut with sleeve

1 110945K017 110945K017 belt guard assembly

7.5 h.p.

1 110258B061 drive belt

1 110828 motor pulley

1 8930 motor bushing

115/230v, 1Ø 200v, 3Ø 230/460v, 3Ø

1 127466J018 8393 127466J029 7.5 h.p. motor (ODP)

* 230 volt only

Part Part Part

Qty Number Number Number Description

120 gal. 200 gal.

1 113467P200 113469P200 tank (200 PSI maximum operating pressure)

2 113281 113281 top plate

1 111136-050 111136-050 tank drain valve

1 111136-100 111136-100 service valve

1 110514-300 110514-300 pressure gauge

2 110512-005 110512-005 pressure switch, 135-175 PSI

1 110513-200 110513-200 pressure relief valve (in tank; 200 PSI)

2 111089-215 111089-215 pressure relief valve (in discharge line; 215 PSI)

2 111491 111491 check valve

2 114559-001 114559-001 discharge tube (3/4" copper tube to be formed by customer)

2 110948-075 110948-075 tube ﬁtting, nut with sleeve

2 110945K017 110945K017 belt guard assembly

7.5 h.p.

2 110258B061 drive belt

2 110828 motor pulley

2 8930 motor bushing

115/230v, 1Ø 200v, 3Ø 230/460v, 3Ø

1 127466J018 8393 127466J029 7.5 h.p. motor (ODP)

* 230 volt only

(QP-7.5 duplex - horizontal tank - electric motor)

Part numbers shown in italics apply to tank mounted units and base mounted units.

The parts listed here are for standard QP-7.5 (up to 175 PSI) units and may or may not be applicable to custom built units. Check with

your local authorized Quincy distributor for parts that can be used for custom built units. Make sure the components you order are rated

within the safe operating limits of your system. If you are doubtful about which components to order, contact your local Quincy distributor.

Part numbers shown in italics apply to tank mounted units and base mounted units.

2022201402, March 2018