Product Manual

Page | 2
When installing or moving the compressor
This compressor is extremely top heavy. The
compressor must be bolted to the floor with
vibration pads before operating to prevent
equipment damage, injury or death. Do Not
tighten bolts completely as this may cause
stress to the tank welds. Chart 1a.
To reduce the risk of a dangerous
environment
1. Keep work area well lit.
2. Operate compressor in a well-ventilated area
free from flammable liquids and vapors.
3. Operate compressor in a ventilated area so
that compressor may be properly cooled and
the surrounding air temperature will not be
more than 100°F.
4. Never use a compressor in a wet
environment.
5. Protect material lines and air lines from
damage or puncture. Keep hose and wires
away from sharp objects, chemical spills, oil,
solvents and wet floors.
Do Not secure compressor with toggle bolts
into drywall. Drywall sheeting or plaster will not
support the weight of the compressor.
Always Shut Off Gas Valve before moving Gas
Drive Compressors
6. A minimum clearance of 18 inches between
the compressor and a wall is required
because objects could obstruct airflow.
7. The compressor should be located where it
can be directly wired to a circuit breaker. The
compressor should be wired by a qualified
electrician.
8. Never store flammable liquids or gases in
the vicinity of an operating compressor.
9. Do Not locate the compressor air inlet near
steam, paint spray, sandblasting areas or
any other source of contamination. The
debris could damage the motor and pump.
Never use plastic (PVC) pipe for compressed
air. Serious injury or death could result.
Never use the shipping skid for mounting the
compressor.
Electric Compressors are not suitable for
outdoor installation.
Gasoline Compressors must be operated
outdoors, sheltered from the weather.
Never install a shut off valve between the
compressor pump and tank. Personal injury
and/or equipment damage could occur.
Before each use
Inspect your work area
1. Keep work area clean. Cluttered areas and
benches invite accidents.
2. The floor must not be slippery from wax or
dust.
Inspect your compressor
1. To reduce the risk of injury from accidental
starting, turn the switch off and disconnect
power.
2. If any part is missing, bent or broken in any
way, or any electrical part does not work
properly, keep the compressor off and
disconnect power. Do Not use if defect is
found.
3. Check hoses for weak or worn condition
before each use, making certain all
connections are secure. Do Not use if defect
WARNING
WARNING
WARNING
CAUTION
NOTICE
NOTICE
WARNING
Flat
Washer
Floor
Compressor
Leg
Vibration Pad
Shim
(If Necessary)
Lag Bolt
Chart 1a