Service manual

B. Test the Multi Display
Observe the center Multi display on the controller. If an error code
is displayed, refer to Error Codes in Chapter 3, Troubleshooting.
C. Test the Controller Operation
Test the Controller Keys
1.
To enter Service mode, press Stop Belt+Faster+Slower. P000
appears in the Select display, indicating that no key is pressed.
On the ClubTrack Plus, the word Service scrolls across the
tri-color display.
On the HR ClubTrack Plus, the screen lists the tests described
below. To perform a test, press the softkey next to the test
name, rather than pressing the indicated key combinations.
2. Press and hold each key in succession to display the
appropriate code in the Select display (the HR ClubTrack Plus
displays text instead of code). P000 should appear when you
release each key.
Test the Keypanel Displays
Press Stop Belt+Up+Down.
• The display cycles though one digit at a time in each display,
starting from left to right across the panel. Each digit displays
the number 8 and the associated decimal point for one second,
then turns off as the next one lights up.