Instructions
QU-1001-HF RFID Card Reader
Manual
Specification:
Working Voltage:DC 9V-16V
Static Current:≤80mA
Reading Range:5~10CM
Support :EM-ID or M1card
Ambient Temperature:-40℃~70℃
Ambient Humidity:10%~90%
International Standard Wiegand Interface
Less than 100M Communication Distance
Installation:
Using “+”type screw driver to loosen the screw between the
panel and mother board. And then embed the motherboard
to the side wall with the plastic plug and screws.
Wire Connection:
WG26/34 RS485 RS232
Red:DC9V-16V Red:DC 9V-16V Red:DC 9V-16V
Black:GND
Green:D0
White:D1
Blue: LED
Yellow:BEEP
Black:GND
Green:4R+
White: 4R-
Black:GND
Green:RX
White:TX
gray :GND to wiegand 34
purple: Door Bell
Notice!
1. Confirm the electric voltage (DC12V) and differentiate
positive anode and cathode of power supply
2. When external Power is used, make sure sharing the
power with Controller Box or using the same GND
3. The wire connects reader to controller, advise use 8
cores stranded twisted pair cable(among them, three
strands are spare, if no need reader show illegal cards by
sound and light, LED wire can not be used, data wire
Data1 Data0 are twisted pair would be better,
we suggest sectional area are 0.22 square millimeter at
least. The length should not exceed 100meters.
Email: kontakt@quio-rfid.de web: http://www.quio-rfid.de/
Quick-Ohm Küpper & Co. GmbH | Cronenfelderstraße. 75 | 42349 Wuppertal | Tel: +49 (0) 202 404329 | Fax: +49 (0) 202 404350