Users Manual

Q2. No or bad connection between the HD transmitter and HD receiver
1) Move the HD transmitter and/or the HD receiver from the immediate vicinity
of the connected HDMI sources and Wi-Fi equipment. These may affect the
range.
2) Slightly adjusting the position of the HD transmitter and/or HD receiver may
already help out.
3) Too much distance or obstacle between HD transmitter and HD receiver.
Try using shorter distances.
4) Disconnect the power adapters from the wall socket and reconnect them to reb
oot the 4K wireless HDMI extender.
Q3. I do have picture, but no (or bad) sound
The Wireless HD supports up to 2CH PCM stereo.
Check the audio setting in the settings menu of the connected HDMI source an
d manually set it to 2CH PCM stereo when the automatic setting does not work.
Q4. The IR blaster doesn’t work
1) Make sure to use the original remote control of the video source.
2) Please stick the IR emiter probe in the surface of IR window of the source
device, if you are not sure the correct positon of IR window of source device,
3) please refer to the manual of source device.
4) Please point the remote control to the IR receiver probe with 5 meters directly.
5) The IR extender cable based on 20KHz-60KHz remote signal protocol, which
support most of the IR remote in the market, for special standard or old remote
may not supported.