Installation Sheet

1of3
For Style ADY5005OZ
Warnings and Cautions
Turn off electricity at circuit breaker or main fuse box before installation. Consult a licensed electrician if in doubt.
These instructions are provided for your safety. It is very important you read them completely before installing the fixture. We strongly
recommend that a licensed, professional electrician perform the installation.
Disconnect fixture from power source before replacing bulbs. Make sure bulbs are given sufficient time to cool before removal.
Pleasegoto forproductcleaningtips.Gotothe selection.
(5)B10CandelabraBasebulbs60WMaximum,bulbsnotincluded.
MinimumHangingHeightis31.5”,MaximumHangingHeightis81”.
30-45minutes
Identifyandinspectallpartsbeforebeginninginstallation.Checkpackagecontentlistanddiagramsbelowtoensureallpartsare
present.Ifanypartsaremissingordamaged,donotattempttoassemble,install,oroperatethefixture.Contactyouroriginalplaceofpurchase.
www.quoizel.com Care+Maintenance
LightSource:
FixtureHangingHeight:
EstimatedAssemblyTime:
Preparation:
ToolsRequired: Flathead screwdriver, Phillips screwdriver, pliers, wire cutters, wire strippers, electrical tape, safety glasses.
Installation Guide #IS-ADY5005OZ
2018 QuoizelInc.
ReleasedDate:2018-09-12
visit us on-line at www.quoizel.com
Package Contents
STEP 1 Install Center Stem, Spacer Tube, Decorative Part,
Fixture Loop and Finial
-
A. (Refer to SOCKET DISTRIBUTION) Unfold support arms to proper
locations.
B. Thread the hex nut end of the Center Stem (I) onto the hex coupling
on the Fixture Body (K). By using pliers, thread the hex nut against
the hex coupling and hand tighten until snug.
C. Place the Spacer Tube (H), the Decorative Part (G) and the Flat
Panel (F) over the top end of the Center Stem (I). Secure by
threading the Fixture Loop (E) onto the Center Stem (I). Hand
tighten until snug.
Hex Coupling
Figure 1
SOCKET DISTRIBUTION
D. Thread the Finial (L) onto the
bottom center of the Fixture
Body (K) and hand tighten
until snug.
Support Arm
A
Crossbar
Assembly
x1
B
C
Fixture Chain
x1
Quick Link
x2
Ceiling
Canopy
x1
D
E
Fixture Loop
x1
F
Flat Panel
x1
G
Decorative Part
x1
I
Center Stem
x1
H
Spacer Tube
x1
J
Fabric Shade
x5
K
Fixture Body
x1
L
Finial
x1
E
F
G
H
I
K
L
STEP 2 Install Crossbar Assembly-
A. Attach the Crossbar Assembly (A) to
the Outlet Box with the head of the
Green Ground Screw facing you.
Secure it with Outlet Box Screws (not
included). Tighten until snug.
Outlet Box
Screw (not
included)
A
Outlet Box
Supply Wires with
Ground Wire
Figure 2