Installation Guide

ToolsRequired:None.
BulbRecommended:
Estimated Assembly Time:
Preparation:
(2)MediumBase75WMaximum,Alternatebulb(2)19WCFL
20-30minutes
Identifyandinspectallpartsbeforebeginninginstallation.Checkpackagecontentlistanddiagramsbelowtobesureallpartsare
present.Ifanypartsaremissingordamaged,donotattempttoassemble,install,oroperatethefixture.Contactcustomerserviceforreplacement
parts.
Warnings and Cautions
1of1
Assembly Instruction Sheet #IS-AG711TVA
For Style AG711TVA
6 CORPORATE PARKWAY
GOOSE CREEK SC 29445
www quoizel com
,.
..
Thank you for purchasing a Quoizel product.
Need assistance with parts or assembly? Call Quoizel customer service at 1-631-273-2700
or visit us on-line at www.quoizel.com
2014 QuoizelInc.
August2014
Turn off electricity at circuit breaker or main fuse box before installation. Consult a licensed electrician if in doubt.
These instructions are provided for your safety. It is very important you read them completely before installing the fixture. We strongly
recommend that a licensed, professional electrician perform the installation.
Disconnect fixture from power source before replacing bulbs. Make sure bulbs are given sufficient time to cool before removal. Do not subject
glass parts to any shock while in operation or shattering may result.
AG711TVA
NOTE: ALL DIMENSIONS
ARE ROUNDED UP TO
THE NEAREST 1/2"
(2) 75W
Bulbs
(Not Supplied)
Medium
Base
PART NUMBER
REPLACEMENT PART
REQ.
NO.
1711TVAAG
BASE
1
1
1
3
Care of Tiffany Style Shade
A new tiffany lamp shade has an oil film applied to the shade that protects the tiffany shade from scratches during shipment. If the oil applied is
too heavy you can remove the excess oil film with a paper towel. Gently wipe away the excess oil.
For general cleaning of tiffany shades use a gentle lemon oil-based furniture polish applied to a soft cloth and wipe gently.
If a white powder appears on the soldered joints of the tiffany shade this is a normal oxidation process. Use a small amount of lemon oil or
mineral oil applied directly to oxidized areas and the soldered area will return to like new.
Finial
x1
Shade
x1
Big
Knurled Nut
x1
Small
Knurled Nut
x1
Check Ring
x1
Nipple with
Hex Nut
x1
Spacer Tube
x1
Bulb (not
Supplied)
Base
x1
A. Thread have hex nut end of Nipple with Hex Nut into Hex Coupling
on the top of Base. By using pliers, thread the hex nut against the
hex coupling and hand tighten until snug.
D. Place Spacer Tube and Check Ring over the Nipple. Secure by
thread Small Knurled Nut onto the Nipple, hand tighten until snug.
E. Thread Big Knurled Nut onto Nipple and adjust it to proper location
for rest components. Place Shade over the Nipple and secure with
the Finial. Hand tighten until snug.
J1109FIVA
FINIAL
2
G2343SH SHADE
3
1
1
8.5” Dia.
17” Dia.
6.5”
25”
2
FINISH: VALIANT BRONZE
F. This fixture uses standard bulb
with medium base . Maximum
75 watts. Insert bulb and screw
snugly into place.
Your fixture is now assembled
and ready to use. Enjoy!