Installation Sheet

Package Contents
Pleasegoto forproductcleaningtips.Gotothe selection.
Flatheadscrewdriver,Phillipsscrewdriver,pliers,wirecutters,wirestrippers,electricaltape,safetyglasses.
(2)A19MediumBaseVintageBulbs100WMaximum,bulbsincluded.
30-45minutes
Identifyandinspectallpartsbeforebeginninginstallation.Checkpackagecontentlistanddiagramsbelowtobesureallpartsare
present.Ifanypartsaremissingordamaged,donotattempttoassemble,install,oroperatethefixture.Contactyouroriginalplaceofpurchase.
www.quoizel.com Care+Maintenance
ToolsRequired:
LightSource:
EstimatedAssembly Time:
Preparation:
Warnings and Cautions
1of2
For Style ANW8602C
Turn off electricity at circuit breaker or main fuse box before installation. Consult a licensed electrician if in doubt.
These instructions are provided for your safety. It is very important you read them completely before installing the fixture. We strongly
recommend that a licensed, professional electrician perform the installation.
Disconnect fixture from power source before replacing bulbs. Make sure bulbs are given sufficient time to cool before removal.
E
B
Lock
Screw
x2
Inner Backplate
x1
STEP 1 Install Inner Backplate and Fixture Body-
A. Pass the supply wires through Inner Backplate (A). Attach Inner
Backplate (A) to Outlet Box with the head of Green Ground Screw
facing you. Secure it with Outlet Box Screws (not included). Tighten
until snug
B. Race all supply wires through the Inner Backplate (A) as shown.
Refer to Step 2 for wiring connections.
C. Attach Fixture Body (C) over Inner Backplate (A) and secure with
Lock Screws (B). Tighten until snug with screwdrivers.
.
A
Shade
x2
C
Fixture
Body
x1
A
Figure 1
Outlet Box
C
B
STEP 3 - Install Shades and Bulbs
A. Place Shade (E) over the Cup, line
up the mounting hole on the Cup
and the hole on the Shade (E),
secure by threading the Lock
Screw (F) onto the mounting hole.
Hand tighten until sung.
B. Insert Bulbs (D) onto sockets and
screw snugly into place.
Your fixture is now assembled and
ready to use. Enjoy!
Cup
Figure 3
D
Vintage
Bulb
x2
F
Lock
Screw
x6
C
E
F
D
STEP 2 - Wire Connections
A. Wrap bare or green ground wire around green ground screw on the
crossbar, no less than 2 inches from the end of the wire. Tighten the
green ground screw.
B. Use standard wire connectors (not included) to make all wire
connections. Twist connectors until wires are tightly joined together.
Wrap each connection with approved electrical tape and carefully
stuff all the connected wires into the Outlet Box.
Figure 2
Green Ground Screw
on the Crossbar
White wire
from outlet box
White wire
from fixture
Black wire from
outlet box (or Red)
Black wire
from fixture
Bare, or Green
Ground wire
from outlet box
Ground wire
from Fixture
Installation Guide #IS- CANW8602
2019 QuoizelInc.
ReleasedDate:2019-01-22
visit us on-line at www.quoizel.com