Installation Sheet

Package Contents
Pleasegoto forproductcleaningtips.Gotothe selection.
(2)A19MediumBaseBulbs100WMaximum
www.quoizel.com Care+Maintenance
ToolsRequired:Flatheadscrewdriver, Phillips screwdriver,pliers,wirecutters,wirestrippers,electricaltape,safetyglasses.
LightSource:
EstimatedAssembly Time:
Preparation:
20-30minutes
Identifyandinspectallpartsbeforebeginninginstallation.Checkpackagecontentlistanddiagramsbelowtobesureallpartsare
present.Ifanypartsaremissingordamaged,donotattempttoassemble,install,oroperatethefixture.Contactcustomerserviceforreplacement
parts.
Warnings and Cautions
1of2
Assembly Instruction Sheet #IS-ARD8602BN
For Style ARD8602BN
2017 QuoizelInc.
Turn off electricity at circuit breaker or main fuse box before installation. Consult a licensed electrician if in doubt.
These instructions are provided for your safety. It is very important you read them completely before installing the fixture. We strongly
recommend that a licensed, professional electrician perform the installation.
Disconnect fixture from power source before replacing bulbs. Make sure bulbs are given sufficient time to cool before removal.
E
B
Mounting Screw
x4
Inner Backplate
x1
STEP 1 Install Inner Backplate-
A. Pass the supply wires with ground wire through the Inner Backplate
(A). Attach the Inner Backplate (A) to the Outlet Box with the
mounting holes on the top and bottom. Secure it with Outlet Box
Screws (not included). Tighten until snug.
A
Shade
x2
D
Fixture Body
x1
A
C
Figure 1
Outlet Box
Outlet Box Screw
(not supplied)
Thank you for purchasing a Quoizel product.
Need assistance with parts or assembly? Call Quoizel customer service at 1-800-645-3184
or visit us on-line at www.quoizel.com
ReleasedDate:2017-09-19
Socket Collar
x2
E
D
Socket
Bulb (not
Supplied)
Supply Wires with
Ground Wire
STEP 3 - Install Fixture Body
A. Place the backplate and the Fixture Body (C) over the Inner
Backplate (A) and secure with Mounting Screws (B). Hand tighten
until snug with screwdrivers.
C
B
A
Backplate
Mounting Hole
Figure 3
STEP 4 - Install Shades and Bulbs
A. Place Shade (D) over Socket and secure with the Socket Collar (E).
Hand tighten until snug.
B. Insert bulbs onto sockets and screw snugly into place.
Your fixture is now assembled and ready to use. Enjoy!
Figure 4
Figure 2
STEP 2 - Wire Connections
A. Wrap bare or green ground wire around green ground screw on the
crossbar, no less than 2 inches from the end of the wire. Tighten the
green ground screw.
B. Use standard wire connectors (not included) to make all wire
connections. Twist connectors until wires are tightly joined together.
Wrap each connection with approved electrical tape and carefully
stuff all the connected wires into the Outlet Box.
Green Ground Screw
on the Crossbar
White wire
from outlet box
White wire
from fixture
Black wire from
outlet box (or Red)
Black wire
from fixture
Bare, or Green
Ground wire
from outlet box
Ground wire
from Fixture