Installation Guide

Warnings and Cautions
1of2
Assembly Instruction Sheet #IS-BRE8411K
For Style BRE8411K
2017 QuoizelInc.
Turn off electricity at circuit breaker or main fuse box before installation. Consult a licensed electrician if in doubt.
These instructions are provided for your safety. It is very important you read them completely before installing the fixture. We strongly
recommend that a licensed, professional electrician perform the installation.
Disconnect fixture from power source before replacing bulbs. Make sure bulbs are given sufficient time to cool before removal.
Pleasegoto forproductcleaningtips.Gotothe selection.
(3)B10CandelabraBasebulbs60WMaximum.
20-30minutes
Identifyandinspectallpartsbeforebeginninginstallation.Checkpackagecontentlistanddiagramsbelowtoensureallpartsare
present.Ifanypartsaremissingordamaged,donotattempttoassemble,install,oroperatethefixture.Contactcustomerserviceforreplacement
parts.
www.quoizel.com Care+Maintenance
LightSource:
EstimatedAssemblyTime:
Preparation:
Fixturecanonlybemountedinthedirectionindicatedonpage2.
ToolsRequired: Flathead screwdriver, Phillips screwdriver, pliers, wire cutters, wire strippers, electrical tape, safety glasses.
ReleasedDate:2017-03-09
Thank you for purchasing a Quoizel product.
Need assistance with parts or assembly? Call Quoizel customer service at 1-800-645-3184
or visit us on-line at www.quoizel.com
Package Contents
A
Crossbar Assembly
x1
C
Fixture
Body
x1
B
Alternate
Mounting screw
x2
G
ND
D
Small
Glass Panel
x4
E
Big Glass Panel
x4
Figure 1
STEP 1 Separate the Cage-
A. Unlock lock balls and remove the
cage from the fixture hood.
Fixture Hood
Lock Ball
Cage
STEP 2 Install Small Glass Panels-
A. Insert the Small Glass Panel (D)
into the fixture hood. Place the
narrow side of the Small Glass
Panel (D) into the slot in the fixture
hood. Fold the tabs in the fixture
hood to another side of the Small
Glass Panel (D) to engage it.
Fixture
Hood
D
Tab
Slot
Figure 2
STEP 3 Install Big Glass Panels-
A. Insert the Big Glass Panel (E) into
the cage. Place the narrow side of
the Big Glass Panel (E) into the
slot in the bottom edge of the cage.
Fold the tabs in the top edge of the
cage to the top side of the Big
Glass Panel (E) to engage it.
Tab
E
Cage
Figure 3
Slot
STEP 4 Install Bulbs-
A. Insert bulbs onto socket and screw
snugly into place.
Figure 4
STEP 5 Install the Cage-
A. Place the cage back onto the fixture
hood with the gap against the
backplate. Secure them with lock
balls and hand tighten until snug.
Figure 5
Fixture
Hood
Lock Ball
Cage
Gap
Backplate
Bulb (not
Supplied)
Socket