Installation Sheet

Package Contents
Warnings and Cautions
1of2
For Style BRS9009AGV
Turn off electricity at circuit breaker or main fuse box before installation. Consult a licensed electrician if in doubt.
These instructions are provided for your safety. It is very important you read them completely before installing the fixture. We strongly
recommend that a licensed, professional electrician perform the installation.
Disconnect fixture from power source before replacing bulbs. Make sure bulbs are given sufficient time to cool before removal.
Pleasegoto forproductcleaningtips.Gotothe selection.
markingpen,1/16”
drillbit,centerpunch,hammer,drillandwrench.
(3)B10CandelabraBaseBulbs60WMaximum,bulbsnotincluded.
20-30minutes
Identifyandinspectallpartsbeforebeginninginstallation.Checkpackagecontentlistanddiagramsbelowtoensureallpartsare
present.Ifanypartsaremissingordamaged,donotattempttoassemble,install,oroperatethefixture.Contactyouroriginalplaceofpurchase.
www.quoizel.com Care+Maintenance
LightSource:
EstimatedAssemblyTime:
Preparation:
ToolsRequired: Flathead screwdriver, Phillips screwdriver, pliers, wire cutters, wire strippers, electrical tape, safety glasses,
Fixture Body
x1
Installation Guide #IS-BRS9009AGV
2018 QuoizelInc.
ReleasedDate:2018-09-13
visit us on-line at www.quoizel.com
A
Mounting Screw
x3
E
Fixture Hood
x1
C
STEP 1 - Install Glass Panels
A. Insert the Glass Panel (D) into
the slot of the cage on the
Fixture Body (E). Secure by
pressing tabs on the top edge of
the cage to the top edge of the
Glass Panel (D).
Figure 1
STEP 2 - Install Bulbs and Fixture
Hood
A. Insert bulbs onto sockets and screw
snugly into place.
B. Place the Fixture Hood (C) onto the top
edge of the Fixture Body (E) and align
mounting holes on the bottom edge of
D
Glass
Panel
x4
B
Lock Screw
x2
Tab
E
D
Slot
Cage
B
C
E
Socket
Bulb (not
included)
Figure 2
the Fixture Hood (C) to
holes on the top edge of
the Fixture Body (E).
Secure by using Lock
Screws (B). Hand
tighten until snug with
screwdrivers.
STEP 3 - Mark the Location for the 3 Mounting Holes
A. Place the light fixture onto the post and mark the location of the 3
mounting holes on the fixture fitter onto the post with the marking
pen.
Fixture
Fitter
Marking Pen
Mounting
Hole
Post
Lighting
Post
Post
Fixture
Fitter
Figure 3