Installation Guide

Package Contents
ToolsRequired:Flatheadscrewdriver, Phillips screwdriver,pliers,wirecutters,wirestrippers,electricaltape,safetyglasses.
BulbRecommended:
EstimatedAssemblyTime:
Preparation:
2
20-30minutes
Identifyandinspectallpartsbeforebeginninginstallation.Checkpackagecontentlistanddiagramsbelowtobesureallpartsare
present.Ifanypartsaremissingordamaged,donotattempttoassemble,install,oroperatethefixture.Contactcustomer service for replacement
parts.
( )G9BaseFrostedG9Halogenbulb,60WMaximum
Warnings and Cautions
1of2
Assembly Instruction Sheet #IS-DVN8602
For Styles DVN8602C and DVN8602BN
Thank you for purchasing a Quoizel product.
Need assistance with parts or assembly? Call Quoizel customer service at 1-631-273-2700
or visit us on-line at www.quoizel.com
2014 QuoizelInc.
Turn off electricity at circuit breaker or main fuse box before installation. Consult a licensed electrician if in doubt.
These instructions are provided for your safety. It is very important you read them completely before installing the fixture. We strongly
recommend that a licensed, professional electrician perform the installation.
Disconnect fixture from power source before replacing bulbs. Make sure bulbs are given sufficient time to cool before removal. Do not subject
glass parts to any shock while in operation or shattering may result.
Do not touch the bulb with bare hands use a cloth or glove.
B
Lock
Screw
x4
Inner
Backplate
x1
STEP 1 Install Inner Backplate and
Fixture Body
-
A. Pass the supply wires through Inner
Backplate (A). Attach Inner Backplate
(A) to Outlet Box with the head of
Green Ground Screw facing you.
Secure it with Outlet Box Screws (not
included). Tighten until snug
B. Race all supply wires through the Inner
Backplate (A) as shown. Refer to Step
2 for wiring connections.
C. Attach Fixture Body (D) over Inner
Backplate (A) and secure with Lock
Screws (B). Tighten until snug with
screwdrivers.
.
A
D
Fixture Body
x1
STEP 2 - Wire Connections
A. Use standard wire connectors (not included) to make all wire
connections. (Connectors are not included with fixture.) Twist
connectors until wires are tightly joined together. Wrap each
connection with approved electrical tape and carefully stuff all the
connected wires between Inner Backplate (A) and Fixture Body (D).
A
White wire
from supply
White wire
from fixture
Black wire from
supply (or Red)
Black wire
from fixture
Ground wire
from supply
Ground wire
from fixture
Figure 2
C
G9 Bulb
x2
Figure 1
Outlet
Box
Outlet Box
Screw
D
B
STEP 3 - Install Shades, Bulbs and Bulb Shields
A. Place Shade (E) over Socket and secure with Socket Collar (G).
B. This fixture uses frosted G9 halogen bulb (C) with G9 base.
C
F
E
Socket
Maximum 60 watts. Insert bulb
and push snugly into place.
C. Thread Bulb Shield (F) onto the
Socket and hand tighten until
snug.
Do not touch the
bulb with bare hands use a cloth
or glove.
Your fixture is now assembled
and ready to use. Enjoy!
IMPORTANT:
Figure 3
E
Bulb Shield
x2
Shade
x2
F
G
Socket Collar
x2
October2014
G