Installation Sheet

1of2
For Style GAR1612SS
Package Contents
Warnings and Cautions
Turn off electricity at circuit breaker or main fuse box before installation. Consult a licensed electrician if in doubt.
These instructions are provided for your safety. It is very important you read them completely before installing the fixture. We strongly
recommend that a licensed, professional electrician perform the installation.
Disconnect fixture from power source before replacing bulbs. Make sure bulbs are given sufficient time to cool before removal.
Crossbar
Assembly
x1
Glass Holder
x4
Fixture Body
x1
Pleasegoto forproductcleaningtips.Gotothe selection.
(2)A19MediumBasebulbs60WMaximum,MediumBaseVintageBulbsarerecommended,bulbsnotincluded.
30-45minutes
Identifyandinspectallpartsbeforebeginninginstallation.Checkpackagecontentlistanddiagramsbelowtoensureallpartsare
present.Ifanypartsaremissingordamaged,donotattempttoassemble,install,oroperatethefixture.Contactyouroriginalplaceofpurchase.
www.quoizel.com Care+Maintenance
LightSource:
EstimatedAssembly Time:
Preparation:
ToolsRequired:Flatheadscrewdriver,Phillipsscrewdriver,pliers,wirecutters,wirestrippers,electricaltape,safetyglasses.
A
Rectangle
Glass
Panel
x4
C
B
D
E
Installation Guide #IS-GAR1612SS
2019 QuoizelInc.
ReleasedDate:2019-03-20
visit us on-line at www.quoizel.com
Square
Glass
Panel
x1
(Step 2 Continued)
ball.
D. Remove the mounting ball and the ceiling canopy. Tighten the lock
washer and the hex nut against the crossbar to secure in place.
STEP 1 Remove Cage from the Fixture Body-
A. Unlock screws and remove cage from the Fixture Body (B).
Figure 1
Screw
Cage
Ceiling Canopy
STEP 2 - Install the Crossbar Assembly to Outlet Box and Adjust
the length of the Nipple
A. Attach the Crossbar Assembly (A) to the outlet box with the head of
the green ground screw facing you. Secure it with outlet box screws
(not included), tighten until snug
B. Crossbar Assembly (B). Adjust
the hex nut and lock washer underside of the crossbar to the middle
of the nipple.
C. Place the ceiling canopy over the end of the nipple against the
ceiling to determine the correct position of the nipple. Thread the
mounting ball onto the nipple. Adjust the nipple to allow the ceiling
canopy to rest against the ceiling when held in place by the mounting
.
Remove the mounting ball from the
Outlet Box Screw
(not included)
Hex Nut and
Lock Washer
Outlet Box
Green Ground Screw
Nipple
A
Ceiling Canopy
Mounting Ball
Figure 2
STEP 3 - Wire Connections
A. Wrap bare or green ground wire around green ground screw on the
crossbar, no less than 2 inches from the end of the wire. Tighten the
green ground screw.
B. Use standard wire connectors (not included) to make all wire
connections. Twist connectors until wires are tightly joined together.
Wrap each connection with approved electrical tape and carefully
stuff all the connected wires into the Outlet Box.
Green Ground Screw
on the Crossbar
White wire
from outlet box
White wire
from fixture
Black wire from
outlet box (or Red)
Black wire
from fixture
Bare, or Green
Ground wire
from outlet box
Ground wire
from Fixture
Figure 3