Installation Guide

1of2
6 CORPORATE PARKWAY
GOOSE CREEK SC 29445
www quoizel com
,.
..
2016 QuoizelInc.
Package Contents
Pleasegoto forproductcleaningtips.Gotothe selection.
(1)A21MediumBasebulb150WMaximum.
www.quoizel.com Care+Maintenance
LightSource:
ToolsRequired: Flathead screwdriver,Phillips screwdriver,pliers, wire cutters, wire strippers, electrical tape, safety glasses.
EstimatedAssembly Time:
Preparation:
20-30minutes
Identifyandinspectallpartsbeforebeginninginstallation.Checkpackagecontentlistanddiagramsbelowtobesureallpartsare
present.Ifanypartsaremissingordamaged,donotattempttoassemble,install,oroperatethefixture.Contactcustomerserviceforreplacement
parts.
Warnings and Cautions
Turn off electricity at circuit breaker or main fuse box before installation. Consult a licensed electrician if in doubt.
These instructions are provided for your safety. It is very important you read them completely before installing the fixture. We strongly
recommend that a licensed, professional electrician perform the installation.
Disconnect fixture from power source before replacing bulbs. Make sure bulbs are given sufficient time to cool before removal.
A
Mounting Screw
x3
Assembly Instruction Sheet #IS-GLD9010WT
For Style GLD9010WT
D
Thank you forpurchasing a Quoizelproduct.
Need assistance withparts or assembly?Call Quoizel customerservice at 1-800-645-3184
or visit us on-line at www.quoizel.com
Fixture Hood
x1
E
Fixture Body
x1
G
Lock Screw
x4
Glass
Panel
x4
F
B
Lock Ball
x2
C
Fixture Loop
x1
STEP 1 Attach Glass Panels to the
Fixture Body
-
A. Insert the Glass Panel (F) into the
cage of the Fixture Body (G). Place
the bottom edge of the Glass Panel
(F) into the slot in the bottom edge of
the cage. And then fold tabs in the
top edge of the cage to secure the
top edge of the Glass Panel (F).
F
G
Figure 1
Slot
Tab
STEP 2 Install the Bulb, the Fixture Hood and the Fixture Loop-
A. Insert the bulb onto socket and screw snugly into place.
B. Place the Fixture Hood (D) onto the top edge of the Fixture Body
(G). Align holes on the Fixture Hood (D) to mounting holes on the
ReleasedDate:2016-11-08
C
D
E
Bulb (not
supplied)
Socket
Mounting
Hole
G
Hole
Bar
Figure 2
STEP 3 Drill Pilot Holes on Post-
A. Carefully fit the Post Fitter over the end
of the Post (not supplied), making sure
the Post Fitter is fully seated.
B. Mark the drill point for the (3) Mounting
Screws, using (3) Mounting Holes as
reference. After marking hole locations,
remove fixture from post and drill 1/16”
pilot holes for screws.
Post
Post Fitter
Figure 3
Mounting Hole
top edge of the cage and the
holes on the bars. Secure them
together by threading Lock
Screws (E) into mounting
holes. Hand tighten until snug.
C. Thread the Fixture Loop (C)
onto the top center of the
Fixture Hood (D). Hand tighten
until snug.