Installation Sheet

1of2
6 CORPORATE PARKWAY
GOOSE CREEK SC 29445
www quoizel com
,.
..
2017 QuoizelInc.
Assembly Instruction Sheet #IS-LLE9011WT
For Style LLE9011WT
Thank you for purchasing a Quoizel product.
Need assistance with parts or assembly? Call Quoizel customer service at 1-800-645-3184
or visit us on-line at www.quoizel.com
Package Contents
A
Mounting Screw
x3
B
Fixture Hood
x1
ReleasedDate:2017-09-14
Warnings and Cautions
Turn off electricity at circuit breaker or main fuse box before installation. Consult a licensed electrician if in doubt.
These instructions are provided for your safety. It is very important you read them completely before installing the fixture. We strongly
recommend that a licensed, professional electrician perform the installation.
Disconnect fixture from power source before replacing bulbs. Make sure bulbs are given sufficient time to cool before removal.
Pleasegoto forproductcleaningtips.Gotothe selection.
(1)A21MediumBasebulb150WMaximumor
(1)MediumBaseVintagebulbisrecommendedbutnotsupplied.
20-30minutes
Identifyandinspectallpartsbeforebeginninginstallation.Checkpackagecontentlistanddiagramsbelowtoensureallpartsare
present.Ifanypartsaremissingordamaged,donotattempttoassemble,install,oroperatethefixture.Contactcustomerserviceforreplacement
parts.
www.quoizel.com Care+Maintenance
LightSource:
EstimatedAssembly Time:
Preparation:
ToolsRequired: Flathead screwdriver,Phillips screwdriver,pliers, wire cutters, wire strippers, electrical tape, safety glasses.
Glass Holder
x1
C
Lock Ball
x2
Glass
Shade
x1
E
D
STEP 1 - Install Bulb and Glass Shade
A. Insert the bulb onto the socket and screw snugly into place.
B. Place the Glass Shade (E) over the bulb carefully. Attach the shade
neck to the fixed shade holder on the Fixture Body (B). With one
Figure 1
E
D
Fixed Shade
Holder
Neck
Bolt
C
E
B
hand holding the Glass
Shade (E), place the Glass
Holder (C) to other side of
shade neck and place it over
bolts on the fixed glass
holder. Secure them together
by threading Lock Balls (D)
onto bolts. Hand tighten until
snug.
STEP 2 - Mark the Location for the 3 Mounting Holes
A. Place the light fixture onto the post and mark the location of the 3
mounting holes on the fixture fitter onto the post with the marking
pen.
Fixture
Fitter
Marking Pen
Mounting
Hole
STEP 3 M C
EM H
- arking the enter of
ach ounting ole
A. Remove the light fixture. Using
the center punch and hammer
marking the center of each
mounting hole location that is
marked with the marking pen.
Center Punch
Hammer
Marking
Post Lighting
Post
Post
STEP 4 Drill Holes-
A. Using the 1/16” bit and drill, drill a pilot hole completely through the
post at each (3) locations marked in step 5 above.
1/16” bit and drill
Post
Post
Fixture
Fitter
Figure 2
Figure 3
Figure 4