Installation Sheet

1of2
Assembly Instruction Sheet #IS-LTT1628EK
For Style LTT1628EK
Pleasegoto forproductcleaningtips.Gotothe selection.
(5)A19MediumBaseBulbs100WMaximum,MediumBaseVintageBulbsarerecommended,bulbsnotincluded.
www.quoizel.com Care+Maintenance
ToolsRequired:Flatheadscrewdriver, Phillips screwdriver,pliers,wirecutters,wirestrippers,electricaltape,safetyglasses.
LightSource:
EstimatedAssembly Time:
Preparation:
20-30minutes
Identifyandinspectallpartsbeforebeginninginstallation.Checkpackagecontentlistanddiagramsbelowtobesureallpartsare
present.Ifanypartsaremissingordamaged,donotattempttoassemble,install,oroperatethefixture.Contactcustomerserviceforreplacement
parts.
Warnings and Cautions
Turn off electricity at circuit breaker or main fuse box before installation. Consult a licensed electrician if in doubt.
These instructions are provided for your safety. It is very important you read them completely before installing the fixture. We strongly
recommend that a licensed, professional electrician perform the installation.
Disconnect fixture from power source before replacing bulbs. Make sure bulbs are given sufficient time to cool before removal.
2018 QuoizelInc.
ReleasedDate:2018-03-02
Thank you for purchasing a Quoizel product.
Need assistance with parts or assembly? Call Quoizel customer service at 1-800-645-3184
or visit us on-line at www.quoizel.com
Package Contents
B
A
C
Mounting Ball
x1
Crossbar Assembly
x1
Fixture Body
x1
STEP 1 Unfold Support Arms-
A. Refer to the illustration, unfold support arms to proper locations.
Support Arm
STEP 2 - Install the Crossbar Assembly to Outlet Box and Adjust
the length of the Nipple
A. Attach the Crossbar Assembly (A) to the Outlet Box with the head of
the Green Ground Screw facing you. Secure it with Outlet Box
Screws (not included), tighten until snug
B. Adjust the hex nut and lock washer underside of the crossbar to the
middle of the nipple.
C. Place the Fixture Body (C) over the nipple against the ceiling to
determine the correct position of the nipple. Thread the Mounting
Ball (B) onto the nipple. Adjust the nipple to allow the Fixture Body
(C) to rest against the ceiling when held in place by the Mounting
.
Figure 1
Outlet Box Screw
(not included)
Hex Nut and
Lock Washer
Outlet Box
Green
Ground
Screw
Figure 2
Nipple
A
B
C
(Step 2 Continued)
Ball (B).
D. Remove the Mounting Ball (B) and the Fixture Body (C). Tighten
the lock washer and the hex nut against the crossbar to secure in
place.
STEP 3 - Wire Connections
A. Wrap bare or green ground wire around green ground screw on the
crossbar, no less than 2 inches from the end of the wire. Tighten the
green ground screw.
B. Use standard wire connectors (not included) to make all wire
connections. Twist connectors until wires are tightly joined together.
Wrap each connection with approved electrical tape and carefully
stuff all the connected wires into the Outlet Box.
Figure 3
Green Ground Screw
on the Crossbar
White wire
from outlet box
White wire
from fixture
Black wire from
outlet box (or Red)
Black wire
from fixture
Bare, or Green
Ground wire
from outlet box
Ground wire
from Fixture