Installation Guide

1of1
Thank you for purchasing a Quoizel product.
Need assistance with parts or assembly? Call Quoizel customer service at 1-631-273-2700
or visit us on-line at www.quoizel.com
2014 QuoizelInc.
July2014
A. Place the Shade, the Diffuser, the Cap and the Flat Washer over the
Stem. Secure by threading the Finial onto the Stem. Hand tighten
until snug.
B. This fixture uses standard bulb with medium base . Maximum 60
watts.
C. Insert bulb and screw snugly into place.
Your fixture is now assembled and ready to use. Enjoy!
Base
x1
MC1862TIB
FINISH: IMPERIAL BRONZE
15”x9”
PART NUMBER
NOTE: ALL DIMENSIONS ARE ROUNDED UP
TO THE NEAREST 1/2"
REPLACEMENT PART DESCRIPTION
NO.
(2)60W
Bulbs
(Not Supplied)
Medium
Base
1
2
3
REQ.
ToolsRequired: Flathead screwdriver, Phillipsscrewdriver, pliers, wirecutters, wire strippers,electricaltape, safety glasses.
BulbRecommended:
Estimated Assembly Time:
Preparation:
(2)Medium Base 60WMaximum,Alternatebulb (2) 13WCFL
20-30minutes
Identifyand inspect allpartsbefore beginning installation.Check package contentlistand diagrams belowto be sureallparts are
present.If any partsaremissing or damaged,do not attempttoassemble, install, oroperate the fixture. Contactcustomer service forreplacement
parts.
Warnings and Cautions
Assembly Instruction Sheet #IS-MC1862TIB
For Style MC1862TIB
6 CORPORATE PARKWAY
GOOSE CREEK SC 29445
www quoizel com
,.
..
Turn off electricity at circuit breaker or main fuse box before installation. Consult a licensed electrician if in doubt.
These instructions are provided for your safety. It is very important you read them completely before installing the fixture. We strongly
recommend that a licensed, professional electrician perform the installation.
Disconnect fixture from power source before replacing bulbs. Make sure bulbs are given sufficient time to cool before removal. Do not subject
glass parts to any shock while in operation or shattering may result.
Care of Tiffany Style Shade
A new tiffany lamp shade has an oil film applied to the shade that protects the tiffany shade from scratches during shipment. If the oil applied is
too heavy you can remove the excess oil film with a paper towel. Gently wipe away the excess oil.
For general cleaning of tiffany shades use a gentle lemon oil-based furniture polish applied to a soft cloth and wipe gently.
If a white powder appears on the soldered joints of the tiffany shade this is a normal oxidation process. Use a small amount of lemon oil or
mineral oil applied directly to oxidized areas and the soldered area will return to like new.
Shade
x1
Finial
x1
1
Bulb
Flat Washer
x1
Cap
x1
Stem
Diffuser
x1
12.5”x6.5”
5.5”
23”
8”x6”
G3932DI DIFFUSER
S1765MC SHADE
1
1
11862TIBMC
BASE 1
2
3