Installation Guide

Warnings and Cautions
1of1
Assembly Instruction Sheet #IS-MC2134TWT
For Style MC2134TWT
6 CORPORATE PARKWAY
GOOSE CREEK SC 29445
www quoizel com
,.
..
Thank you for purchasing a Quoizel product.
Need assistance with parts or assembly? Call Quoizel customer service at 1-631-273-2700
or visit us on-line at www.quoizel.com
2015 QuoizelInc.
September2015
Turn off electricity at circuit breaker or main fuse box before installation. Consult a licensed electrician if in doubt.
These instructions are provided for your safety. It is very important you read them completely before installing the fixture. We strongly
recommend that a licensed, professional electrician perform the installation.
Disconnect fixture from power source before replacing bulbs. Make sure bulbs are given sufficient time to cool before removal. Do not subject
glass parts to any shock while in operation or shattering may result.
MC2134TWT
PART NUMBER
NOTE: ALL DIMENSIONS ARE ROUNDED
UP TO THE NEAREST 1/4"
REPLACEMENT PART DESCRIPTION
NO.
(2) 60W
Bulbs
(Not Supplied)
Medium
Base
1
2
12134TWTMC
S12134MC
BASE
SHADE
REQ.
1
1
1
16” Dia.
24”
2
FINISH: WESTERN BRONZE
Pleasegoto forproduct cleaningtips. Goto the selection.
(2)A19MediumBase 60WMaximum,Alternatebulb (2)13W CFL
15-20minutes
Identifyand inspectall partsbefore beginninginstallation. Checkpackage contentlist anddiagrams belowto besure allparts are
present.If anyparts aremissing ordamaged, donot attemptto assemble,install, oroperate thefixture. Contactcustomer servicefor replacement
parts.
www.quoizel.com Care+ Maintenance
LightSource:
Estimated Assembly Time:
Preparation:
ToolsRequired: None.
Base
x1
A. Thread the Socket Assembly, the Rod and the Base together as
shown. Hand tighten until snug.
B. Thread one end of the Stem onto the top center of the Socket
Assembly and hand tighten until snug.
Pull the cord from the Base as you
assemble the parts together to remove the excess cord between
parts.
Bulb (not
included)
Rod
x1
Socket
Assembly
x1
Stem 3.25”L
x1
Shade
x1
Diffuser
x1
Washer
x1
Finial
x1
Cord
C. Place the Shade, the
Diffuser and the Washer
over the top end of the
Stem. Secure by
threading the Finial onto
the Stem. Hand tighten
until snug.
D. This fixture uses
standard bulb with
medium base . Maximum
60 watts. Insert bulb and
screw snugly into place.
Your fixture is now
assembled and ready to
use. Enjoy!
6.5”
6.75” Dia.
3 G12134DI DIFFUSER
1
3