Installation Guide

1of2
Assembly Instruction Sheet #IS-NYL9011K
For Style NYL9011K
Thank you for purchasing a Quoizel product.
Need assistance with parts or assembly? Call Quoizel customer service at 1-631-273-2700
or visit us on-line at www.quoizel.com
2015 QuoizelInc.
November2015
Pleasegoto forproduct cleaningtips. Goto the selection.
LED16W
www.quoizel.com Care+ Maintenance
LightSource:
ToolsRequired: Flatheadscrewdriver,Phillipsscrewdriver,pliers,wire cutters,wire strippers,electrical tape,safety glasses.
EstimatedAssemblyTime:
Preparation:
20-30minutes
Identifyand inspectall partsbefore beginninginstallation. Checkpackage contentlist anddiagrams belowto besure allparts are
present.If anyparts aremissing ordamaged, donot attemptto assemble,install, oroperate thefixture. Contactcustomer servicefor replacement
parts.
Warnings and Cautions
Turn off electricity at circuit breaker or main fuse box before installation. Consult a licensed electrician if in doubt.
These instructions are provided for your safety. It is very important you read them completely before installing the fixture. We strongly
recommend that a licensed, professional electrician perform the installation.
Disconnect fixture from power source before replacing bulbs. Make sure bulbs are given sufficient time to cool before removal. Do not subject
glass parts to any shock while in operation or shattering may result.
Package Contents
A
Mounting
Screw
x3
Figure 1
STEP 1 Install Cap to Fixture Body-
A. Threading the Cap (B) onto the
Fixture Body (C), hand tighten until
sung.
STEP 2 Drill Pilot Holes on Post-
A. Carefully fit the Post Fitter over the
end of the Post (not supplied), making
sure the Post Fitter is fully seated.
B. Mark the drill point for the (3)
Mounting Screws, using (3) Mounting
Holes as reference. After marking hole
locations, remove fixture from post
and drill 1/16” pilot holes for screws.
Post
Post Fitter
Figure 2
Mounting Hole
Fixture
Body
x1
C
STEP 3 - Wire Connections
A. Use standard wire connectors (not included) to make all wire
connections. (Connectors are not included with fixture.) Twist
connectors until wires are tightly joined together. Wrap each
connection with approved electrical tape and carefully stuff all the
connected wires into the Outlet Box.
White wire
from supply
White wire
from fixture
Black wire from
supply (or Red)
Black wire
from fixture
Ground wire
from supply
Ground wire
from fixture
Figure 3
Cap
x1
B
C
B
STEP 4 - Attach Fixture Body
to Post
A. Coat the top 1” of the Post
with Clear Silicone Caulk (not
supplied) and position the
Post Fitter onto the Post. Be
sure to seat it completely,
aligning the holes in the Fitter
with the 1/16” Pilot Holes
drilled into the Post.
B. Secure the Fixture to Post
with (3) Mounting Screws (A).
Your fixture is now
assembled and ready to use.
Enjoy!
Figure 4
Post
Post Fitter
Mounting Hole
A