Installation Guide

Package Contents
1of2
Assembly Instruction Sheet #IS-PCAX8603C
For Styles PCAX8603C and PCAX8603CLED
Thank you for purchasing a Quoizel product.
Need assistance with parts or assembly? Call Quoizel customer service at 1-631-273-2700
or visit us on-line at www.quoizel.com
2015 QuoizelInc.
December2015
Rev.B
Inner Crossbar
x1
A
Fixture
Body
x1
E
F
STEP 3 - Install Fixture Body
A. Remove mounting screws from the Inner Backplate (A). Place the
backplate of the Fixture Body (F) over the outlet box and secure
with mounting screws. Hand tighten until snug.
A
A
F
F
TOP VIEW
SIDE VIEW
STEP 4 - Install Bulbs
A. Install either the G9 Xenon bulb as specified (not provided) or install
the G9 LED bulbs (provided) if the fixture purchased is the LED
model.
This fixture is rated to use 40W maximum G9 Xenon bulbs.Note:
Socket
Figure 4
E
Figure 3
Mounting
Screw
B
Self-tapping Screw
x4
C
Wall Anchor
x4
Washer
x4
D
STEP 1 Install Crossbar Assembly-
A. Attach the Inner Crossbar (A) to the Outlet Box with the head of the
Green Ground Screw facing you. Line up a set of holes on the Inner
Crossbar (A) to the mounting holes on the Outlet Box. With a pencil,
mark four points from the holes on the Inner Crossbar (A) for Wall
Anchors (C).
B. Remove the Inner Crossbar (A). Drill proper holes at the marks for
Wall Anchors (C). Insert Wall Anchors (C) into the drilled holes.
Outlet Box Screw
(not included)
A
Outlet Box
Supply Wire and
Ground Wire
B
C
D
C. Race supply wires and
ground wires through the
holes as shown. Attach Inner
Crossbar (A) back onto the
Outlet Box and Wall Anchors.
Secure by threading Outlet
Box Screws (not supplied)
into the mounting holes on
the Outlet Box and threading
Self-tapping Screws (B) with
Washers (D) into Wall
Anchors (C). Hand tighten
until snug.
Figure 1
STEP 2 - Wire Connections
A. Use standard wire connectors (not included) to make all wire
connections. (Connectors are not included with fixture.) Twist
connectors until wires are tightly joined together. Wrap each
connection with approved electrical tape and carefully stuff all the
connected wires into the Outlet Box.
White wire
from supply
White wire
from fixture
Black wire from
supply (or Red)
Black wire
from fixture
Ground wire
from supply
Ground wire
from fixture
Figure 2
Pleasegoto forproduct cleaningtips. Goto the selection.
(3)LED G94.5W Bulbs,Maximum 40WG9 XenonClear Bulbs
www.quoizel.com Care+ Maintenance
Note:
ToolsRequired: Flatheadscrewdriver,Phillipsscrewdriver,pliers,wire cutters,wire strippers,electrical tape,safety glasses.
LightSource:
EstimatedAssemblyTime:
Preparation:
20-30minutes
Identifyand inspectall partsbefore beginninginstallation. Checkpackage contentlist anddiagrams belowto besure allparts are
present.If anyparts aremissing ordamaged, donot attemptto assemble,install, oroperate thefixture. Contactcustomer servicefor replacement
parts.
Ifthe styleyou purchasedis PCAX8603Cit isNOT providedwith lightbulbs. Ifthe styleyou purchasedisPCAX8603CLEDitisprovidedwith(3)
G9LED lightbulbs. TheG9 LEDbulb isan energyefficientbulb andwill reducethe useof electricityin comparisonto G9Xenon bulbs,saving you
money. Pleasego toQuoizel.com tosee theG9 LEDbulb specificationsprovided withyour fixture.
Warnings and Cautions
Turn off electricity at circuit breaker or main fuse box before installation. Consult a licensed electrician if in doubt.
These instructions are provided for your safety. It is very important you read them completely before installing the fixture. We strongly
recommend that a licensed, professional electrician perform the installation.
Disconnect fixture from power source before replacing bulbs. Make sure bulbs are given sufficient time to cool before removal. Do not subject
glass parts to any shock while in operation or shattering may result.
(Step 2 Continued)
You may use a lower wattage G9 Xenon
or if you purchased the LED model it is
supplied with G9 LED bulbs.
Your fixture is now assembled and ready
to use. Enjoy!
CAUTION FOR BULB REPLACING
When replacing bulbs, turn off power and allow lamp to cool. For safety
purpose, wear gloves and eye protection.
LED G9 Bulb
x3
Included with
PCAX8603CLED model only.