Installation Sheet

Pleasegoto forproductcleaningtips.Gotothe selection.
Flatheadscrewdriver,Phillipsscrewdriver,pliers,wirecutters,wirestrippers,electricaltape,safetyglasses.
IntegratedLED33W
20-30minutes
Identifyandinspectallpartsbeforebeginninginstallation.Checkpackagecontentlistanddiagramsbelowtoensureallpartsare
present.Ifanypartsaremissingordamaged,donotattempttoassemble,install,oroperatethefixture.Contactyouroriginalplaceofpurchase.
www.quoizel.com Care+Maintenance
ToolsRequired:
LightSource:
EstimatedAssemblyTime:
Preparation:
1of1
PCBD8519EK
FINISH: EARTH BLACK
NOTE: ALL DIMENSIONS ARE ROUNDED UP
TO THE NEAREST 1/4"
Package Contents
B
Mounting Screw
x4
Inner Backplate
x1
A
C
Fixture Body
x1
D
Shade
x1
F
Bracket
x2
19”
D
F
E
Shade Holder
STEP 1 Install Inner Backplate and Fixture Body-
A. Pass the supply wires and ground wire through the Inner Backplate
(A). Attach the Inner Backplate (A) to outlet box with the head of
green ground screw facing you. Secure it with outlet box screws
(not included). Tighten until snug
B. Refer to Step 2 for wiring connections.
C. Attach the Fixture Body (C) over the Inner Backplate (A) and secure
with Mounting Screws (B). Tighten until snug with screwdrivers.
.
A
Figure 1
Outlet Box Screw
(not included)
C
B
STEP 3 Install Shade to Fixture Body-
A. Insert Shade (D) into the Shade Holder properly.
B. Place Bracket (F) over the side of the Shade Holder, line up the hole
on the Bracket (F) and the mounting hole on the Shade Holder,
secure by threading Lock Screw (E) into the mounting hole, tighten
until sung.
Your fixture is now assembled and ready to use. Enjoy!
E
Lock Screw
x4
4.5”
6.5”
4.5”
For Style PCBD8519EK
Installation Guide #IS-PCBD8519EK
Warnings and Cautions
Turn off electricity at circuit breaker or main fuse box before installation. Consult a licensed electrician if in doubt.
These instructions are provided for your safety. It is very important you read them completely before installing the fixture. We strongly
recommend that a licensed, professional electrician perform the installation.
2019 QuoizelInc.
ReleasedDate:2019-01-22
visit us on-line at www.quoizel.com
Outlet Box
Supply Wires and
Ground Wire
STEP 2 - Wire Connections
A. Wrap bare or green ground wire around green ground screw on the
crossbar, no less than 2 inches from the end of the wire. Tighten the
green ground screw.
B. Use standard wire connectors (not included) to make all wire
connections. Twist connectors until wires are tightly joined together.
Wrap each connection with approved electrical tape and carefully
stuff all the connected wires into the Outlet Box.
Figure 2
Green Ground Screw
on the Crossbar
White wire
from outlet box
White wire
from fixture
Black wire from
outlet box (or Red)
Black wire
from fixture
Bare, or Green
Ground wire
from outlet box
Ground wire
from Fixture
Figure 3