Installation Sheet

Package Contents
Pleasegoto forproductcleaningtips.Gotothe selection.
:LutronAYCL-153PorLutronDVCL-153P.
www.quoizel.com Care+Maintenance
CompatibleDimmerSwitches
ToolsRequired:Flatheadscrewdriver, Phillips screwdriver,pliers,wirecutters,wirestrippers,electricaltape,safetyglasses.
LightSource:
EstimatedAssembly Time:
Preparation:
IntegratedLED37W
20-30minutes
Identifyandinspectallpartsbeforebeginninginstallation.Checkpackagecontentlistanddiagramsbelowtobesureallpartsare
present.Ifanypartsaremissingordamaged,donotattempttoassemble,install,oroperatethefixture.Contactcustomerserviceforreplacement
parts.
Warnings and Cautions
1of2
Assembly Instruction Sheet #IS-PCWR8524C
For Style PCWR8524C
2017 QuoizelInc.
Turn off electricity at circuit breaker or main fuse box before installation. Consult a licensed electrician if in doubt.
These instructions are provided for your safety. It is very important you read them completely before installing the fixture. We strongly
recommend that a licensed, professional electrician perform the installation.
B
Mounting
Screw
x4
Inner Backplate
x1
STEP 2 Install Inner Backplate-
A. Pass the supply wires and ground wire through the Inner
Backplate (A). Attach the Inner Backplate (A) to Outlet Box with
the head of Green Ground Screw facing you. Secure it with Outlet
Box Screws (not included). Tighten until snug.
A
D
Fixture Body
x1
C
Figure 2
Thank you for purchasing a Quoizel product.
Need assistance with parts or assembly? Call Quoizel customer service at 1-800-645-3184
or visit us on-line at www.quoizel.com
ReleasedDate:2017-10-12
Glass Panel
x1
A
Outlet Box
Outlet Box Screw
(not supplied)
Supply Wires and
Ground Wire
STEP 1 Install Glass Panel to Fixture Body-
B. Remove lock nuts and rubber washers from glass holders. Attach
the Glass Panel (C) to the bolts on glass holders. Secure by
threading rubber washers and lock nuts back onto bolts. Hand
tighten until snug.
C. Attach glass holders back onto the Fixture Body (D) and secure with
previously removed lock screws. Tight until snug with screwdrivers.
A. Place the Fixture Body (D) onto a flat working surface. Unlock lock
screws from the back of the Fixture Body (D) and remove the glass
holder on both ends.
Figure 1
STEP 3 - Wire Connections
A. Wrap bare or green ground wire around green ground screw on the
crossbar, no less than 2 inches from the end of the wire. Tighten the
green ground screw.
B. Use standard wire connectors (not included) to make all wire
connections. Twist connectors until wires are tightly joined together.
Wrap each connection with approved electrical tape and carefully
stuff all the connected wires into the Outlet Box.
Figure 3
Green Ground Screw
on the Crossbar
White wire
from outlet box
White wire
from fixture
Black wire from
outlet box (or Red)
Black wire
from fixture
Bare, or Green
Ground wire
from outlet box
Ground wire
from Fixture
Rubber Washer
Lock Nut
Bolt
Lock Screw
D
C
Glass Holder