Installation Guide

ManualsBrandsQuoizel ManualsPost Light BasesPO9140K

INSTRUCTION SHEET IS-PO9140

STYLE NUMBER: PO9140XX

ISSUED 10-2010 REVISED 2013-12-17

PACKAGE CONTENTS

PART

DESCRIPTION

QUANTITY

Big Allen Wrench

1pc

3pcs

Anchor Bracket

Allen Bolt

Lock Ball

Hex Nut

Anchor Bolt

1OF4

6 CORPORATE PARKWAY

GOOSE CREEK SC 29445

www quoizel com

WARNING:

CAUTION:

● Before beginning the installation, turn off electricity at the circuit breaker box or the main fuse box by switching

off the circuit breaker or removing the fuse.

● These instructions are provided for your safety. It is very important that they are read completely before the

installation of your fixture. We strongly recommend that a professional electrician install the fixture.

● Disconnect fixture from the power source before replacing the bulb(s), making sure that bulb(s) had sufficient

time to cool down. DO NOT subject the lamp to any shock while lit as shattering of lamp may result.

WARNINGS AND CAUTIONS

● Before beginning installation of product, make sure all parts are present. Compare parts with package contents

list and diagram above. If any part is missing or damaged, do not attempt to assemble, install or operate the

product. Contact customer service for replacement part.

● Estimated Assembly Time: 30 - 45 minutes

● Tool Required for Assembly (not included): Flathead screwdriver, Phillips screwdriver, Shovel, Electrical tape,

Wire cutter, Safety glasses and proper length Wires (not supplied)

● Helpful Tools (not included): Wire strippers.

PREPARATION

Allen Set Screw

Lock Washer

Washer

4pcs

1pc

Upper Post

Middle Post

Bottom Post

1pc

Post Fitter

Small Allen Wrench

1pc

Summary of content (4 pages)

PAGE 1
6 CORPORATE PARKWAY GOOSE CREEK , SC . 29445 www . quoizel .
PAGE 2
INSTALLATION INSTRUCTIONS STYLE NUMBER: PO9140XX STEP 1: Hex Nut a. Remove all Washers, Hex Nuts and Lock Balls from the Anchor Bolts. b. Screw the threaded end of each Anchor Bolt in the Mounting Bracket making sure to that the Anchor Bolt is 1.75” to 2” extended from the bottom of the Bracket. c. Place a Lock Washer over the Anchor Bolt and then thread the Hex Nut onto each Anchor bolt. Securing the Bracket in place maintaining the 1.75”-2” length of the Anchor Bolt.
PAGE 3
INSTALLATION INSTRUCTIONS STYLE NUMBER: PO9140XX STEP 3: Post Fitter a. Place the Post Fitter on the Upper Post end without the threads. Secure the Post Fitter with (2) Allen Set Screw using the Small Allen Wrench provided. b. Thread the Upper Post assembly onto the Middle Post until secure. Secure the Upper Post assembly to the Middle post using (2) Allen Set Screw and the Small Allen Wrench provided. c.
PAGE 4
INSTALLATION INSTRUCTIONS STYLE NUMBER: PO9140XX STEP 5: a. Place the Post Mount assembly onto the Anchor Bolts. Place a Washer over each Anchor Bolt and secure each Anchor Bolt with the Lock Ball and tighten until secure. Bottom Post Lock Ball Washer Anchor Bracket Earth Your installation is completed now. Restore electricity. Retain this sheet for future reference.