Installation Guide

1of1
Assembly Instruction Sheet #IS-Q2605FOI
For Style Q2605FOI
6 CORPORATE PARKWAY
GOOSE CREEK SC 29445
www quoizel com
,.
..
Thank you for purchasing a Quoizel product.
Need assistance with parts or assembly? Call Quoizel customer service at 1-631-273-2700
or visit us on-line at www.quoizel.com
2016 Quoizel Inc.
January2016
A. Insert the nipple on
the Tube into the
Base. Place Lock
Washer over the
nipple, secure by
using Wrench thread
the Hex Nut onto the
nipple, hand tighten
until snug.
B. Threading Tube with
Switch onto the Tube,
hand tighten until
snug.
C. Connect the Quick
Connectors.
D. Insert Arm Assembly
into the Tube. Line up
the hole on the Tube
and the mounting hole
on the Socket
Assembly, secure by
threading Lock Screw
into the mounting
hole. Hand tighten
until sung.
E. Attach Socket
Assembly to the
fixture. By using Allen
Wrench thread Allen
Screw into the
mounting hole on the
Socket Assembly,
tighten until snug.
F. This fixture uses
standard bulb with
medium base .
Maximum 60 watts.
Insert bulb and screw
snugly into place.
Your fixture is now
assembled and ready
to use. Enjoy!
Q2605FOI
NOTE:
ALL DIMENSIONS ARE
ROUNDED UP TO THE
NEAREST 1/4"
(3) 60W
Bulbs
(Not Supplied)
Medium
Base
Pleasegoto forproduct cleaningtips. Goto the selection.
(3)A19MediumBase 60Wbulb Maximum,Alternatebulb(3) 13WCFLMaximum.
15-20minutes
Identifyand inspectall partsbefore beginninginstallation. Checkpackage contentlist anddiagrams belowto besure allparts are
present.If anyparts aremissing ordamaged, donot attemptto assemble,install, oroperate thefixture. Contactcustomer servicefor replacement
parts.
www.quoizel.com Care+ Maintenance
LightSource:
Estimated Assembly Time:
Preparation:
Tools Required: None.
Warnings and Cautions
Turn off electricity at circuit breaker or main fuse box before installation. Consult a licensed electrician if in doubt.
These instructions are provided for your safety. It is very important you read them completely before installing the fixture. We strongly
recommend that a licensed, professional electrician perform the installation.
Disconnect fixture from power source before replacing bulbs. Make sure bulbs are given sufficient time to cool before removal. Do not subject
glass parts to any shock while in operation or shattering may result.
PART NUMBER REPLACEMENT PART
REQ.
NO.
1
2
Wrench
x1
Lock
Washer
x1
Hex Nut
x1
Tube
x1
Base
x1
FINISH: OIL RUBBED BRONZE
Tube with Switch
x1
Switch
Allen Wrench
x1
Allen Screw
x3
Shade
x3
Socket Collars
x3
Socket
Lock
Screw
x1
Arm Assembly
x1
Bulb
42.5”
13.5”Dia.
90.25”
10”
9”Dia.
Quick
Connector
S12746FA SHADE
3
1