Installation Guide

1of2
6 CORPORATE PARKWAY
GOOSE CREEK SC 29445
www quoizel com
,.
..
2017 QuoizelInc.
Pleasegoto forproductcleaningtips.Gotothe selection.
markingpen,1/16”
drillbit,centerpunch,hammer,drillandwrench.
(1)A21MediumBaseBulb150WMaximum.
www.quoizel.com Care+Maintenance
LightSource:
ToolsRequired: Flathead screwdriver,Phillips screwdriver,pliers, wire cutters, wire strippers, electrical tape, safety glasses,
EstimatedAssembly Time:
Preparation:
20-30minutes
Identifyandinspectallpartsbeforebeginninginstallation.Checkpackagecontentlistanddiagramsbelowtobesureallpartsare
present.Ifanypartsaremissingordamaged,donotattempttoassemble,install,oroperatethefixture.Contactcustomerserviceforreplacement
parts.
Assembly Instruction Sheet #IS-RPT9011PN
For Style RPT9011PN
Thank you for purchasing a Quoizel product.
Need assistance with parts or assembly? Call Quoizel customer service at 1-800-645-3184
or visit us on-line at www.quoizel.com
Warnings and Cautions
Turn off electricity at circuit breaker or main fuse box before installation. Consult a licensed electrician if in doubt.
These instructions are provided for your safety. It is very important you read them completely before installing the fixture. We strongly
recommend that a licensed, professional electrician perform the installation.
Disconnect fixture from power source before replacing bulbs. Make sure bulbs are given sufficient time to cool before removal.
Package Contents
A
Mounting Screw
x3
Fixture Body
x1
B
ReleasedDate:2017-04-20
STEP 4 M C
EM H
- arking the enter of
ach ounting ole
A. Remove the light fixture. Using
the center punch and hammer
marking the center of each
mounting hole location that is
marked with the marking pen.
Center Punch
Hammer
Marking
STEP 5 Drill Holes-
A. Using the 1/16” bit and drill, drill a pilot hole completely through the
post at each (3) locations marked in step 4 above.
1/16” bit and drill
Post
Post
Figure 4
Figure 5
STEP 1 - Remove Styrofoam inside
of the Cage
A. Unscrew lock screws on the fixture
hood by using screwdrivers and
remove the fixture hood from the
Fixture Body (B).
B. Carefully remove the Styrofoam
inside of the Fixture Body (B).
STEP 2 Install the Bulb and
Fixture Hood
-
A. Install the bulb onto socket and
screw snugly into place.
B. Place the fixture hood onto the top
edge of the cage and the Fixture
Body (B) and secure with lock
screws. Hand tighten until snug
with screwdrivers.
Figure 2
Bulb (not
supplied)
Socket
Lock
Screw
Styrofoam
Cage
Fixture Hood
Figure 1
Lock Screw
Fixture Hood
Cage
STEP 3 - Mark the Location for the 3 Mounting Holes
A. Place the light fixture onto the post and mark the location of the 3
mounting holes on the fixture fitter onto the post with the marking
pen.
Fixture
Fitter
Marking Pen
Mounting
Hole
Post
Lighting
Post
Post
Fixture
Fitter
Figure 3