Installation Guide

2of2
STEP 4 - Install Bulb
A. This fixture uses standard bulb with
standard screw base. Maximum 100
watts. Insert bulb and screw snugly
into place.
Your fixture is now assembled and
ready to use. Enjoy!
Bulb
Figure 5
Socket
HOW TO REPLACE GLASS PANELS
Allen Screw
Screw
Glass Panel
Cage
A. By unscrewing Allen Screws,
remove the Cage from the Fixture
Hood.
B. Unscrew Screws on the top of the
Cage. Remove the Glass Holder
from the Cage. Remove the broken
Glass Panel inside of the Cage and
insert the replacement Glass Panel.
C. Place the Glass Holder back onto
the top of the Cage and secure with
Screws. Hand tighten until snug.
D. Attach the Cage with Glass Panels
back onto the Fixture Hood and
secure with Allen Screws. Hand
tighten until snug.
Figure 6
Glass
Holder
Fixture
Hood
2018 QuoizelInc.
ReleasedDate:2018-11-12
visit us on-line at www.quoizel.com
Figure 3
STEP 3 - Making the Wire Connections
A. Wrap bare or green ground wire around green ground screw on the
crossbar, no less than 2 inches from the end of the wire. Tighten the
green ground screw.
Use standard wire connectors (G) to make all wire connections.
Twist connectors until wires are tightly joined together. Wrap each
connection with approved electrical tape and carefully stuff all the
connected wires into outlet box.
Note: If the electrical wire is going to be cut shorter than provided
you will need to identify the "L" line wire and the "N" neutral wire
before you cut the excess wire off. One is labeled N and the other
labeled L. To do this separate the "L" line wire and the "N" neutral
wire as far as you need to. Re-label the wire near where you want to
make the cut. Be sure to mark the wire on the side of the fixture and
not on the excess wire being cut and removed.
B.
Green Ground Screw
on the Crossbar
White wire
from outlet box
White wire from fixture
identified with the Label ā€œNā€
Black wire from
outlet box (or Red)
Black wire from fixture
identified with the label ā€œLā€
Bare, or Green
Ground wire
from outlet box
Ground wire
from Fixture