Installation Sheet

ToolsRequired:Flatheadscrewdriver, Phillips screwdriver,pliers,wirecutters,wirestrippers,electricaltape,safetyglasses.
Estimated Assembly Time:
Preparation:
20-30minutes
Identifyandinspectallpartsbeforebeginninginstallation.Checkpackagecontentlistanddiagramsbelowtobesureallpartsare
present.Ifanypartsaremissingordamaged,donotattempttoassemble,install,oroperatethefixture.Contactcustomerserviceforreplacement
parts.
BulbRecommended: (1)CandelabraBase25WMaximum.
Warnings and Cautions
1of1
Assembly Instruction Sheet #IS-TF1018TVB
For Style TF1018TVB
6 CORPORATE PARKWAY
GOOSE CREEK SC 29445
www quoizel com
,.
..
Thank you for purchasing a Quoizel product.
Need assistance with parts or assembly? Call Quoizel customer service at 1-631-273-2700
or visit us on-line at www.quoizel.com
2014 QuoizelInc.
June2014
Turn off electricity at circuit breaker or main fuse box before installation. Consult a licensed electrician if in doubt.
These instructions are provided for your safety. It is very important you read them completely before installing the fixture. We strongly
recommend that a licensed, professional electrician perform the installation.
Disconnect fixture from power source before replacing bulbs. Make sure bulbs are given sufficient time to cool before removal. Do not subject
glass parts to any shock while in operation or shattering may result.
Care of Tiffany Style Shade
A new tiffany lamp shade has an oil film applied to the shade that protects the tiffany shade from scratches during shipment. If the oil applied is
too heavy you can remove the excess oil film with a paper towel. Gently wipe away the excess oil.
For general cleaning of tiffany shades use a gentle lemon oil-based furniture polish applied to a soft cloth and wipe gently.
If a white powder appears on the soldered joints of the tiffany shade this is a normal oxidation process. Use a small amount of lemon oil or
mineral oil applied directly to oxidized areas and the soldered area will return to like new.
A. Install the Harp by pressing the ends of the Harp into the Harp Clips
as shown.
B. Place Shade over the Nipple on the top of Harp, secure by threading
Finial onto the Nipple, hand tighten until sung.
C. This fixture uses candelabra bulb with standard screw base.
Maximum 25 watts.
D. Insert bulb and screw snugly into place.
Your fixture is now assembled and ready to use. Enjoy!
Shade
X1
Figure 1
TF1018TVB
PART NUMBER
NOTE: ALL DIMENSIONS ARE ROUNDED
UP TO THE NEAREST 1/2"
REPLACEMENT PART DESCRIPTION
NO.
1
2
11018TVBTF
M1373FIVA
BASE TF1018TVB
FINIAL
REQ.
1
1
Harp
x1
Finial
X1
Finish: VINTAGE BRONZE
(1) 25W Candelabra
Bulbs
(Not Supplied)
Base
Harp
Clip
Base
x1
Nipple
3.5”Sq.
12”
5.5”
5”Sq.
3 G2765SH SHADE
1
1
2
3