Installation Sheet

Pleasegoto forproductcleaningtips.Gotothe selection.
(2)MediumBaseBulbs60WMaximum
20-30minutes
Identifyandinspectallpartsbeforebeginninginstallation.Checkpackagecontentlistanddiagramsbelowtobesureallpartsare
present.Ifanypartsaremissingordamaged,donotattempttoassemble,install,oroperatethefixture.Contactcustomerserviceforreplacement
parts.
www.quoizel.com Care+Maintenance
BulbRecommended:
Estimated Assembly Time:
Preparation:
ToolsRequired:Pliers.
Warnings and Cautions
1of1
Assembly Instruction Sheet #IS-TF3181T
For Style TF3181T
2017 QuoizelInc.
ReleasedDate:2017-03-02
Turn off electricity at circuit breaker or main fuse box before installation. Consult a licensed electrician if in doubt.
These instructions are provided for your safety. It is very important you read them completely before installing the fixture. We strongly
recommend that a licensed, professional electrician perform the installation.
Disconnect fixture from power source before replacing bulbs. Make sure bulbs are given sufficient time to cool before removal.
Care of Tiffany Style Shade
A new tiffany lamp shade has an oil film applied to the shade that protects the tiffany shade from scratches during shipment. If the oil applied is
too heavy you can remove the excess oil film with a paper towel. Gently wipe away the excess oil.
For general cleaning of tiffany shades use a gentle lemon oil-based furniture polish applied to a soft cloth and wipe gently.
If a white powder appears on the soldered joints of the tiffany shade this is a normal oxidation process. Use a small amount of lemon oil or
mineral oil applied directly to oxidized areas and the soldered area will return to like new.
A. Thread the Hex Nut end of the Nipple with Hex Nut into the hex
coupling on the top center of the Base. By using pliers, thread the
Hex Nut against the hex coupling and hand tighten until snug.
B. Place the Spacer and the Check Ring over the top end of the Nipple
and secure with the Small Knurled Nut. Hand tighten until snug.
C. Thread the Big Knurled Nut onto the top end of the Nipple and
adjust it to proper location for rest components. Place the Flat
Washer and the Shade over the Nipple. Secure by threading the
Finial onto the Nipple. Hand tighten until snug.
D. Insert bulbs onto sockets and screw snugly into place.
Your fixture is now assembled and ready to use. Enjoy!
Finial
x1
Shade
x1
Bulb (not
included)
TF3181T
NOTE: ALL DIMENSIONS ARE ROUNDED
UP TO THE NEAREST 1/4"
Flat Washer
x1
Big Knurled
Nut x 1
3.25”L Spacer Tube
x1
Small
Knurled Nut
x1
3.5”L Nipple
with Hex Nut
x1
14” Dia.
6”
14.5”
7.5” Dia.
Base
x1
FINISH: VALLIANT BRONZE
6 CORPORATE PARKWAY
GOOSE CREEK SC 29445
www quoizel com
,.
..
Thank you for purchasing a Quoizel product.
Need assistance with parts or assembly? Call Quoizel customer service at 1-800-645-3184
or visit us on-line at www.quoizel.com
Cord
Check Ring
x1