Installation Guide

Quoizel, Inc.
6 Corporate Parkway
Goose Creek, SC 29445
Customer Service
Phone [phone]
Fax [phone]
www.quoizel.com
ToolsRequired:Flathead screwdriver,Phillips screwdriver,pliers, wirecutters, wirestrippers, electricaltape,
safetyglasses.
EstimatedAssemblyTime:30-45minutes
Preparation:Identify andinspect allparts beforebeginning installation.Check packagecontent listand diagrams
belowto besure allparts arepresent. Ifany partsare missingor damaged,do notattempt toassemble, install,or
operatethe fixture.Contact customerservice forreplacement parts.
Warnings and Cautions
1of2
Assembly Instruction Sheet #IS-TML9008K
For Style TML9008K
BulbRecommended: (3) CandelabraBase 60WMaximum,Alternatebulb(3) 13WCFL
6 CORPORATE PARKWAY
GOOSE CREEK SC 29445
www quoizel com
,.
..
Thank you for purchasing a Quoizel product.
Need assistance with parts or assembly? Call Quoizel customer service at 1-631-273-2700
or visit us on-line at www.quoizel.com
2014 QuoizelInc.
February2014
Turn off electricity at circuit breaker or main fuse box before installation. Consult a licensed electrician if in doubt.
These instructions are provided for your safety. It is very important you read them completely before installing the fixture. We strongly
recommend that a licensed, professional electrician perform the installation.
Disconnect fixture from power source before replacing bulbs. Make sure bulbs are given sufficient time to cool before removal. Do not subject
glass parts to any shock while in operation or shattering may result.
Package Contents
C
Fixture
Body
x1
A
Mounting
Screw
x3
B
Glass Panel
x4
STEP 2 - Attach Glass to Fixture
Body
A. Attach Glass Panels (B) on the
Fixture Body (C).
Figure 2
C
B
STEP 4 - Attach Fixture Hood
A. Thread the Stem onto the
Coupling inside of Fixture Body
(C), hand tighten until sung.
B. Place the Fixture Hood and the
Waterproof Washer over the
Stem. Secure by threading the
Finial onto the Stem. Hand
tighten until snug.
Figure 4
G
Coupling
STEP 5 Drill Pilot Holes on
Post
-
A. Carefully fit the Post Fitter over
the end of the Post (not
supplied), making sure the
Post Fitter is fully seated.
B. Mark the drill point for the (3)
Mounting Screws, using (3)
Mounting Holes as reference.
After marking hole locations,
remove fixture from post and
drill 1/16” pilot holes for
screws.
Post
Post Fitter
Figure 5
STEP 3 Install Bulb-
A. This fixture uses candelabra bulb
with a candelabra screw base.
Maximum 60 watts.
B. Insert bulb and screw snugly into
place.
Figure 3
Bulb
Socket
STEP 1 Seperate the parts from
the fixture
-
A. Unscrew the Finial, remove the
Waterproof Washer, the Cap
and the Stem from the fixture
(C).
Figure 1
C
Finial
Cap
Waterproof
Washer
Stem
Finial
Cap
Waterproof
Washer
Stem