Install Sheet

1. Make sure the wiring is safely inside the
outlet box as instructed in Step 5 -
Electrical Connections. To install the
canopy, removing the 1 of 2 screws from the
bottom of the mounting bracket and loosening
the other one a half turn from the screw head.
Slide the canopy up to mounting bracket and
place the key hole on the canopy over the screw
on the mounting bracket, turn canopy until it
locks in place at the narrow section of the key
holes. Secure tightening the two set screws.
(Fig. 9)
2. Blade Assembly & Installation (Fig. 10)
Caution: Remove 5 rubber packing mounts
and discard before installation. Using the
supplied blade arm screws, attach the blades
to the blade arms. In some cases the metal
washer is permanently fixed to the screw
head. Ensure all screws are used for each
blade. Next attach the blades to the motor
assembly using the supplied screws. DO
NOT bend the blade arms when installing
the blades.
3. Attaching the Switch Housing Plate
(Fig. 11)
Attach the switch housing plate to the flange
of the motor by using the three (3) screws
provided that are pre-installed on the flange.
4. Attaching the Switch Housing
Assembly (Fig. 12) Snap together the
cannon plug, attach the switch housing
assembly to the switch housing plate with
the three (3) screws provided.
A certain amount of wobble may be
considered normal, especially if the fan is on
a downrod long than 12".
6. COMPLETING THE INSTALLATION
Fig. 10
Fig. 9
Canopy
Screws
Outlet box
Hanger bracket
Fig. 11
Fiber
washers
Screws
Blades
Screws
Blade arms
Flange
Switch
housing
plate
Screws
Fig. 12
Connon plug
Switch
housing
plate
Screws
Switch
housing
assembly