User's Manual

SAFETY INSTRUCTIONS / RADIO INTERFERENCE
28
MosaiQ 125 - User Manual - November 2020 - Reference n°: MMSURM.0010.02
4.6 RADIO INTERFERENCE
This section provides information about the risks of radio interference and the safe
operation of the MosaiQ125.
The MosaiQ125 is a Class A digital device in accordance with CISPR 11 and FCC Rules.
The MosaiQ125 complies with the following standards and rules for information concerning
radio interference:
 IEC 61326-2-6 (Class A for emissions) and IEC 61326-1.
 47 CFR Part 15, Subpart B, of the FCC Rules.
Electromagnetic Compatibility (EMC)
INFO
The MosaiQ 125 complies with the emissions and immunity
requirements as described in standard IEC 61326-2-6. The MosaiQ125
has been developed and tested according to CISPR11 Class A. It may
cause radio interference in domestic environments.
If the MosaiQ125 causes radio interference, you may need to take
measures to eliminate the interference.
The electromagnetic environment shall be evaluated before
installation and operation of the MosaiQ125.
Do not use the MosaiQ125 in the proximity of sources with excessive
electromagnetic radiation (e.g. unshielded, deliberately operated
high frequency sources) since they could interfere with the proper
operation of the MosaiQ125.
FCC Statements
CAUTION
Changes or modifications not expressly approved by the party
responsible for compliance could void the user’s authority to
operate the MosaiQ 125.
INFO
The MosaiQ 125 has been tested and found to comply with the
limits for a Class A digital device, pursuant to part 15 of the FCC
Rules. These limits are designed to provide reasonable protection
against harmful interference when the equipment is operated in
a commercial environment. This equipment generates, uses, and
can radiate radio frequency energy and, if not installed and used
in accordance with the instruction manual, may cause harmful
interference to radio communications. Operation of this equipment
in a residential area is likely to cause harmful interference in which
case the user will be required to correct the interference at his own
expense.
This device complies with part 15 of the FCC Rules. Operation is
subject to the following two conditions: (1) This device may not
cause harmful interference, and (2) this device must accept any
interference received, including interference that may cause
undesired operation.
4.7 LABORATORY EQUIPMENT
WARNING
All biological materials must be regarded as being potentially
hazardous. All cuts and abrasions on hands must be covered.
Gloves and safety glasses should be worn when handling samples
and biological materials.
CAUTION
Strictly follow your laboratory rules regarding protective clothing.