User's Manual
OPERATING INSTRUCTIONS / HOW TO REMOVE AND LOAD EACH RESOURCE
84
E
MosaiQ 125 - User Manual - November 2020 - Reference n°: MMSURM.0010.02
7.3.12 LOADING THE WATER CANISTER
This section explains how to load the water canister into the MosaiQ 125. The water
canisters are located in the water drawer.
The water drawer can be opened and closed manually when the MosaiQ125 is in operation
if a canister needs to be replaced or refilled.
CAUTION
The water canister must be filled in accordance with the laboratory
local manual handling guidelines for maximum weight limit at
work. It is recommended to make a visual mark on the canister to
visualize the filling limit complying with the maximum weight as
per local regulation.
When filled with 10 L of purified water, a canister can weigh up to
11,2 kg.
NOTICE
• The MosaiQ 125 requires purified water (i.e. deionized water).
For more information on the water quality required, please
contact your local technical representative.
• The purified water must be used at room temperature.
• At a minimum, one 10 L canister must be present for the system
to operate.
• Up to two 10 L canisters can be installed at the same time.
To load the water canister:
1 - Open the water canister screw cap and fill it with 10 L of purified water.
2 - Close the screw cap.
3 - Open the water drawer.
4 - Insert the canister into the MosaiQ 125 straightforward, to prevent damaging the
connection between the canister and the reservoir.
(loading of the water canister, mind the water canister / reservoir connection)
5 - Press down on the front of the canister.
6 - Ensure that the water canister is fitted correctly to the intermediate reservoir to avoid
any leakage of purified water.