Quuppa Locator : Installation Guide : Page 10

Connect the Q35 to a network with an Ethernet cable using the RJ-45 Ethernet socket. For your safety

and to prevent any damage to the device, only connect the Q35 to standard certified network

components.

When the Q35 is properly connected to the network, but not activated by the QPE software, the red

indicator light blinks slowly. The blue indicator light flashes or is statically lit when the Q35 is activated by

the QPE software. If needed, it is possible to turn the Locator’s indicator light LED off when in tracking

mode. For more information, please see separate instructions.

The table below shows the different Locator modes as indicated by the Locator’s indicator light.

Colour Sequence

Sequence Description

Indicator Light Mode

Flash red - green - blue once

Reboot sequence

Static red

Locator powered, no IP address

Flashing red

Locator connected to network

Static blue

Locator in tracking mode

Flashing blue

Locator in deployment mode

Flashing white

Locator firmware upgrade in progress

Flash red twice, pause and repeat

Locator subscription not valid

LED off

Optional indicator light state for

tracking mode

ESD Precautions

To prevent damage to the device caused by electrostatic discharge (ESD) during the installation process,

please follow the recommendations listed below.

● Use shielded Ethernet cables.

● Use the connector provided in the product box to attach the cables and avoid touching the

signal cable directly.

10/21

Quuppa Q35 Locator Installation Guide and Safety Information

Quuppa Oy, Keilaranta 1, 02150 Espoo, Finland

Customer Confidential