User's Manual

Troubleshoot
34
Qwizdom Actionpoint 2007
and click on the
Configuration Settings
button. The
Configuration Settings
window will appear. If you are using a fixed set, (the remotes will always be used
with the same hosts) you will want to select that option and click on the
Assign
button. The
Remote Assignment
window will appear. Click on the
Host
drop-down
menu to select the host you would first like to assign numbers to. The default
session ID will appear on the right. You may type your own session ID there if you
prefer. Click on
Start
and then turn on the desired number of remotes (no higher
than 1000). When you are done with the first host, click on
Stop
and put the
remotes aside for they will be turned off. Click on the
Host
drop-down menu and
select the next host. Select or enter the session ID and click on
Start
. Turn on the
desired number of remotes (no higher than 1000) and click on
Stop
when finished.
When all remotes have been assigned to the hosts, click on
OK
.
Click on the
Presentation
button and click on the
Remote Settings
tab. You will
see all available hosts listed there. Select the host(s) you will be using. If you
specified a unique session ID during the assigning process, be sure that you type
that number under the
User Session
column. Select all the other appropriate
choices in the setup area and click the
OK
button to begin your presentation.
16)
How do I select the correct answer for a slide?
There are two ways to select the answer for a slide:
Click on the
Answer
drop-down menu and select the correct answer.
Type in an answer and press the
Enter
key
to apply the answer. If you do not press
Enter
, the default value will appear in the answer field.
17)
A window keeps appearing that says '
Resume Slide Show
' after I begin my
presentation. How do I get stop this from happening?
To stop this window from appearing, click on the X to close the window out. If you
select '
Resume
', the window will continue to appear in subsequent presentations.
18)
I entered the time/points in the
Timer/Points
field but the value doesn't save.
How do I get it to save?
If you type in a value, you must press the
Enter
key on the keyboard to apply it.
19)
In the
Configurations Settings
window, how do I know if I should use
Fixed set
or
Roaming or Participant Owned
mode?
Fixed set
mode should be used if the same group of remotes will always be used
with the same host. This scenario is most common in corporate and K-12 settings.
If you are going to share the set of remotes, you can still use this mode as long as
the remotes always stay with the same host. The remotes are assigned a fixed
number and the session ID is permanently assigned to the remotes. Participants
may still log in using their participant ID if you select the option in the
Presentation
Setup
window. This option allows the participant to pick up any remote rather than
having to use the same remote each time.