User Manual

CA630 System (0510-1116-A) - In-Service Manual 7
Chapter 2
Set Up
Setting Up The System
NOTE: When positioning the control unit, ensure that the speakers holes and
indicator lights are not covered.
1. Visually inspect the sensor pad and sensor pad wires for damage. If damaged,
replace the damaged pad before proceeding.
2. Visually inspect the control unit for damage. Also inspect all other cords,
connectors, and sensors for damage. Replace if damaged.
3. Power the control unit by inserting a 9-volt alkaline battery into the battery
receptacle on the back of the control unit or connecting the plug-in power
supply. The unit will beep and the power indicator light will flash to show
operations.
Fall Alert
1. Refer to the instructions on the Sensor Pad for placement of the pad on the bed
or chair.
2. Connect the sensor pad to the control unit and position the patient on the pad. The
control unit beeps once and the green light flashes every 2-seconds to indicate the
system is monitoring. If cords is damaged or disconnected, an alarm will sound at
the control unit.