User's Manual

Series 5.0 Software (0510-1059-A_DRAFT) - User Guide 11
9450 System
Mother Transmitter
A Mother transmitter is placed on the wrist of a new mother and then linked to an Infant
transmitter. When the Infant transmitter is in contact with the Mother transmitter, the
Mother transmitter flashes Green LED to indicate that the Infant and Mother
transmitters match. If there is a mismatch, meaning the Infant and Mother transmitters do not match, the
Mother transmitter flashes the Red LED three times, and sounds a three beep alarm. A Mismatch Transmitter
alarm is also generated in the Event List. If there is a linking problem, a Link Transmitter alarm is
generated in the Event List.
In cases where the Mother Transmitter is linked but no longer active (e.g. the patient has been
discharged but the transmitter was never cleared) the transmitter will beep after 24 hours of inactivity.
If the transmitter go undetected and allowed to beep for 15 minutes, it will clear and discharge itself
from the system. Tapping the Mother Transmitter will temporality stop the beeping but the
transmitter remains in a linked state until manually cleared (refer to the Mother Baby Match Mother
Transmitter User Guide). If not cleared, the transmitter will beep again after another 24 hours of
inactivity.
NOTE: Asset transmitters can also be linked to Mother transmitters. When an asset
transmitter is linked to the Mother transmitter, all linked functions are applicable.
CAUTION: The Mother Transmitter can be worn in the shower; complete
submersion should be avoided. Prolonged submersion may result in equipment
and/or system failure and voids any or all Product Warranty.