User's Manual

Series 5.0 Software (0510-1059-A_DRAFT) - User Guide 17
9600 QR System
To set up the Nurse Call for use
1. Activate the Nurse Call by pressing the button.
If the Nurse Call is working properly, an Assistance Required alarm event will be listed on the Event
List at the Central Server. The system senses the Nurse Call when it goes into alarm and adds it to its list
of devices.
2. Reset the Nurse Call by pulling the button back to the UP position. The alarm event will automatically
clear from the Event List at the Central Server. If Enforced JCAHO is enabled, you must clear the
alarm at the Central Server.
3. At the Central Server, update the Nurse Call information, for example, giving the Nurse Call a name
and/or assigning it to a room or unit. Refer to the “Update Devices” section in the Series 5.0 Software
Administrator Guide.
Smoke Detector
If your facility is using wireless Smoke Detectors in conjunction with your Series
5.0 Software, a Smoke alarm event is reported in the Event List each time a Smoke
Detector is activated. A Smoke Detector is supervised; a routine signal is sent from
the device and if the signal is not received by the system, a Device Fault event is
generated in the Event List. Smoke Detectors are available from RF Technologies,
Inc.; refer to the manufacturer’s instructions for information regarding mounting,
inserting the batteries, and testing.
The Smoke Detector is powered by a 3V battery with a 3 to 5-year life, based on use. Following these instruction
to insert the battery and set up the Smoke Detector for use.
To insert the battery
1. With the Smoke Detector facing you, remove the detector body
from its mounting base by twisting the detector counter
clockwise.
2. Insert two AA half-size batteries into the battery holder as shown.
Be sure to align the positive (+) end of the battery as marked on
the batteries and battery holder.
3. Replace the detector back onto its mounting base.