User's Manual

Chapter 1: Equipment Overview
20 Series 5.0 Software (0510-1059-A_DRAFT) - User Guide
To set up the Door/Window Transceiver for use
1. Activate the Door/Window transceiver by opening the door or window.
If the transceiver is working properly, an Exit alarm event will be listed on the Event List at the Central
Server. The system senses the Door/Window transceiver when it goes into alarm and adds it to its list of
devices.
2. Reset the Door/Window transceiver by closing the door or window and pressing the EMERGENCY
reset button if applicable.
If the transceiver is reset properly, the alarm event will automatically clear from the Event List at the
Central Server. If Enforced JCAHO is enabled, you must clear the alarm at the Central Server.
3. At the Central Server, update the Door/Window transceiver information, for example, giving it a name
and/or assigning it to a room or unit. Be sure to enable the Inactivity Check-In feature and select
beginning and end times. Refer to the “Update Devices” section in the Series 5.0 Software Administrator
Guide.