User's Manual

Series 5.0 Software (0510-1059-A_DRAFT) - User Guide 43
Common Operations
10. Select SAVE.
If the admit is successful, you will get the following dialog box:
FIGURE 3.6: Update Successful Dialog Box
11. Click OK.
For more information on the Transmitter tab, refer to “Enter Transmitter Information” on page 47.
To admit with a Fixed device
1. Click Admit on the toolbar.
2. If necessary, swipe your identification card or enter your Login and Password then press Enter or click
OK.
The Admit Selection window appears (refer to Figure 3.3 on page 41).
3. Select New Admit to bring up the Admit Information window and enter admit information (see
“Patient Admit Information Window” on page 44).
4. Enter patient information (name and unit required).
5. Select the Room that was configured with device from the drop-down menu.
6. Click Save.
NOTE: Fixed devices, such as a pull-cord or smoke detector, are assigned to a room and/or
unit at the Configuration level. Refer to the Series 5.0 Software Administrator Guide.