User's Manual

Industry Canada Compliance
Changes or modifications not expressly approved by RF Technologies could void the user’s authority to
operate the equipment. The Term “IC” before the radio certification number only signifies that Industry
Canada technical specifications were met.
Operation is subject to the following two conditions: (1) this device may not cause harmful interference,
and (2) this device must accept any interference received, including interference that may cause undesired
operation of the device.
This device has been designed to operate with the antennas listed below, and having a maximum gain of
3dBi. Antennas not included in this list or having a gain greater than 3dBi are strictly prohibited for use
with this device. The required antenna impedance is 50 ohms. Acceptable antennas are PCB antennas in
all cases of the Router which uses a 2.4 GHz 1/2 wave RP-SMA.
To reduce potential radio interference to other users, the antenna type and its gain should be so chosen
that the equivalent isotropically radiated power (e.i.r.p.) is not more than that permitted for successful
communication.