User Manual
Table Of Contents
- In-Service Guide
- Compliance
- Federal Communication Commission (FCC) Compliance
- Industry Canada Compliance
- Important Warnings
- Overview
- About this Guide
- Additional Detailed Documentation
- Contact Information
- Product Warranty
- Chapter 1
- Main Menu
- Alarms Menu
- Silence Alarms
- No Signal (option not shown)
- Help Call/Clear
- Charging the Care Manager
- Chapter 2
- Chapter 3
- Specifications
Compliance
Federal Communication Commission (FCC)
Compliance
FCC ID: KXU-PGR2CCZ24
IC: 2719A-PGR2CCZ24
This device complies with Part 15 of the FCC rules. Operation is subject to the
following to conditions: (1) This device may not cause harmful interference, and
(2) this device must accept any interference received, including interference that
may cause undesired operations.
Changes or modifications not expressly approved by RF
Technologies could void the user’s authority to operate the equipment.
FCC and IC Radiation Exposure Statement for Portable Devices
(For the Care Manager model 9600-0500)
This equipment complies with FCC and IC radiation exposure limits set forth for an
uncontrolled environment. This equipment is in direct contact with the body of the
user under normal operating conditions. This transceiver must not be co-located or
operating in conjunction with any other antenna or transceiver.
Industry Canada Compliance
Changes or modifications not expressly approved by RF Technologies could void the user’s
authority to operate the equipment. The Term “IC” before the radio certification number only
signifies that Industry Canada technical specifications were met.
Operation is subject to the following two conditions: (1) this device may not cause harmful
interference, and (2) this device must accept any interference received, including
interference that may cause undesired operation of the device.
This device has been designed to operate with the antennas listed below, and having a
maximum gain of 3dBi. Antennas not included in this list or having a gain greater than 3dBi
are strictly prohibited for use with this device. The required antenna impedance is 50 ohms.
Acceptable antennas are PCB antennas in all cases of the Router which uses a 2.4 GHz 1/2
wave RP-SMA.
To reduce potential radio interference to other users, the antenna type and its gain should be
so chosen that the equivalent isotropically radiated power (e.i.r.p.) is not more than that
permitted for successful communication.
Copyright 2010 by RF Technologies, Inc.
All Rights Reserved. No Part of this work may be reproduced or copied in any form
or by any means without written permission from RF Technologies, Inc.