User's Manual

Mounting Tags
The Seeker Tag can be attached using an adhesive pad that can be purchased with the
Tag. The following section provides detailed steps about applying the Tag using the
adhesive.
To apply the adhesive pad to the Tag
1. Remove an adhesive pad from the strip of paper.
2. Turn the Tag onto its front.
3. Line the adhesive pad up with the back of the Tag.
4. Apply the adhesive pad.
5. Verify that the pad is applied correctly and is not
hanging over the sides of the Tag.
To attach a Tag to a resource using an adhesive pad
1. Obtain the asset to which you want to apply the tag.
2. Remove the adhesive plastic guard.
3. Firmly attach the tag to the asset.
4. Press firmly on the tag to verify that it adhered to the
asset
Mounting Suggestions
• The front of the tag should face the expected position from which searches will be
performed.
• Do not place the tag inside of a metal container because the signal will be blocked.
• Test for Tag reception by performing a search after you mount the Tag.
• Do not block the sounder hole on the Tag or tag volume is decreased.
• Perform a search to verify that the audible tone is loud enough and that the light is
visible.
You can use other ways to attach a tag to a resource. For
example, a loop mount zip tie.
NOTE: Before mounting the tags be sure to program them to reflect the correct
department and tag IDs. See Programming Tags for more information.
It is much easier to search for a resource if we can associate it with its attached tag.
The Tag Entry window performs the association between the tag and its resource.
To associate a tag with a resource
1. In the Tag Entry list, select an item
to edit.
2. Click Edit.
The Edit Tag window appears.
3. In the Resource box, type the name
for this resource.
4. In the Description box, type a
description for this resource.
5. Click … to open the Save Dialog
window.
6. Select the bitmap to be used to
represent the resource.
7. Click OK, to save the changes.
Editing Tags
Deleting Tags
To delete a tag resource association
1. In the Tag Entry list, select an item to delete.
2. Click Delete.
The item disappears from the list.
7
16