User's Manual

Series 6.0 Software (0510-1065-A) - User Guide 49
Common Operations
10. The Supervised option is selected by default. If desired, deselect.
11. Select SAVE.
If the admit is successful, you will get the following dialog box:
12. Click OK.
For more information on the Transmitter tab, refer to “Enter Transmitter Information” on page 55.
To admit with a fixed device
1. Click Admit on the toolbar.
2. If necessary, use your proximity card or magnetic/barcode card or enter your Login and Password then
press Enter or click OK.
The Admit Selection window appears (refer to Figure 3.1 on page 45).
3. Select Manual Admit to bring up the Admit Information window.
4. Enter patient information; the yellow fields designate required entry.
5. Select the Room that was configured with device from the drop-down menu.
6. Click Save.
NOTE: Pull Cords and Smoke Detectors are considered fixed devices. They are assigned to a
room and/or unit at the Configuration level. Refer to the Series 6.0 Software Administrator
Guide.