Owner`s manual

18
FIREPLACE INSTALLATION (cont.)
Middle Body
1. Place the middle body piece on top of the base body piece.
Carefully align the pilot holes, and repeat the hardware
installation process (large hardware kits). See Fig. 18-1.
2. Return to the base body hardware and completely
tighten.
For Cordova and Reduced Cordova proceed to the
LINERS, TOP BODY, & CHIMNEY section. For Grand
Cordova models, continue on to the following section.
Grand Cordova ONLY - Side Walls
1. Locate the four pieces required to assemble one complete
side wall.
2. Place the rear side-wall piece beside the fi replace body
as shown. Carefully align the pilot holes, and repeat the
hardware installation process (large hardware kits). See
Fig. 18-2.
3. Place the front side-wall piece beside the fi replace body
as shown. Carefully align the pilot holes, and repeat the
hardware installation process (large hardware kits). See
Fig. 18-3.
4. Place the end side-wall piece against the front and rear
side-walls as shown in Fig. 18-4 (no hardware required).
5. Slide the top side-wall piece onto the front and rear side-
walls as shown in Fig. 18-5 (no hardware required). This
will secure the entire side wall.
6. Repeat assembly for the opposite side.
Fig. 18-1 Assemble middle body
Fig. 18-2 Assemble rear side-wall (skip if n/a)
Fig. 18-3 Assemble front side-wall (skip if n/a)
Fig. 18-4 Assemble end side-wall (skip if n/a)
Fig. 18-5 Assemble top side-wall (skip if n/a)
Grand Cordova Only:
Side Walls
Hardware:
Large
Bolts x 4
Nuts x 4
Washers x 8
Hardware:
Large
Bolts x 2
Nuts x 2
Washers x 4
Hardware:
Large
Bolts x 3
Nuts x 3
Washers x 6