Owner`s manual

6
Important: When the burner system is installed
outdoors, ensure it is not directly exposed to
the elements (precipitation, rain, wind, etc.).
REFER TO THE BURNER PARTS LIST WHEN FOLLOWING
THESE INSTRUCTIONS.
1. MAKE SURE THE FIREPLACE GAS SUPPLY IS
TURNED OFF.
2. Locate the gas-supply stub inside the fi replace and
remove the cap, if attached (reference Fig. 6-1).
CAUTION: When removing the cap, make sure the stub does
not turn, loosening the connection inside the wall.
3. Place the burner system in the fi replace. Center the burner
in the fi replace. (Reference Fig. 6-2 for orientation.)
4. Be sure gas to the fi replace is off. Remove the adapter
that is loosely connected to the fl ex connector (coming
off of the burner system). Attach the adapter to the gas-
supply stub using a pipe compound resistant to all gasses.
Tighten securely. Then attach the open end of the fl ex
connector to the adapter. Tighten securely (See Fig. 6-1).
5. LEAK TEST: Use a long-necked butane lighter, or lay
a lighted match next to the burner pipe, and carefully
turn on the gas supply until the burner ignites. Test at all
connections for leaks using the appropriate soapy water
solution. If bubbles appear, a leak is present. Turn off the
gas and tighten at all connections. Repeat until no leaks
are present. If a leak persists, turn off the gas supply and
contact the local gas company or dealer. NEVER USE
A FLAME TO CHECK FOR LEAKS.
Turn off the gas supply prior to proceeding.
6. The burner system must be secured to the fi replace fl oor.
The unit has anchoring tabs located on the bottom ends.
With the unit centered, mark and then drill two
1
/
4
" pilot
holes, one on each side of the burner, on opposite ends
7. Reposition the burner over the pilot holes and insert the
provided hammer screws. Carefully hammer the screws
in as shown in Fig. 6-3.
8. Use a power drill to complete the fastening of the screws
(Fig. 6-4).
The Real-Fyre burner system must be installed by a qualifi ed professional service technician. Instructions must
be followed carefully to ensure proper performance and full benefi t from the burner system. Check to be sure
the burner system is designed and labeled for the type of gas (natural gas only) supplied to the fi replace.
Fireplace fl oor must be level, clean, and smooth.
WARNING: Failure to position the parts in accordance with these diagrams or failure to use only parts
specifi cally approved with this appliance may result in property damage or personal injury.
BURNER INSTALLATION
Fig. 6-3 Installing hammer screws
Fig. 6-2 Orientation
Fig. 6-4 Fastening hammer screws
Fig. 6-1 Connect gas supply
Flex connector
Adapter
Gas supply stub