Owner`s manual

Note: Should the burner need to be removed for

servicing; ﬁ rst unfasten the screw, then use a ﬂ at

head screwdriver to pry up the anchoring tab until

the wedge anchor pops out. See Fig.7-1. The screw

assembly is reusable.

9. Each side of the burner has tabs designed to hold the

glass panels in place. First loosen the screws on the

tabs with a screwdriver. Then position a glass panel in

place, secure the tabs up against the panel, and fasten

the screws. Repeat for the opposite side. Reference Fig.

7-2 and Fig. 7-3.

10. Remove the protective coating off of the reﬂ ective front

covers. DO NOT use a sharp object to remove coating.

Install the covers onto each side of the burner system

(see Fig. 7-4).

Turn off the gas supply prior to proceeding.

BURNER INSTALLATION (cont.)

Fig. 7-1 If removal is required

(Remove)

(pry up)

Fig. 7-2 Glass panel positioning

Fig. 7-3 Securing glass panel

Fig. 7-4 Front cover installed