Owner`s manual

FOR YOUR SAFETY, READ BEFORE LIGHTING

WARNING: If you do not follow these instructions exactly, a ﬁ re or explosion may result, causing

property damage, personal injury, or loss of life.

Use only a proper key to turn the gas supply valve. Never use tools. If the valve will not turn, DO NOT try

to repair it. Call a qualiﬁ ed professional service technician. Force or attempted repair may result in ﬁ re or

explosion.

BEFORE LIGHTING, smell all around the burner area for gas. Be sure to smell next to the ﬂ oor, as some

gas is heavier than air and will settle on the ﬂ oor. IF YOU SMELL GAS, FOLLOW THE INSTRUCTIONS

ON PG. 1.

LIGHTING INSTRUCTIONS

1. STOP! Read the safety information above.

2. Insert the key into the key valve and completely turn

the valve clockwise toward the OFF position until it no

longer rotates.

3. Wait 5 minutes for the gas to clear out.

4. Lay a lighted long-stem match on the surface of the

decorative media near the burner (do not hold the

match in your hand) or use a lighted long-necked

butane lighter (Fig. 9-1).

5. Once the match is burning and in position, slowly

turn the key valve counter-clockwise toward the ON

position until it no longer rotates (see Fig. 9-2). Your

burner should light.

CAUTION: If the burner does not light before the match

goes out, immediately turn the key valve

clockwise toward the OFF position until it no

longer rotates.

Wait approximately ﬁ ve (5) minutes to clear

out any gas, and repeat steps 1-5 above.

If your burner fails to light again, turn the key valve

clockwise toward the OFF position until it no longer

rotates and contact your dealer or gas supplier.

TO SHUT OFF GAS TO THE APPLIANCE

To extinguish your gas burner, insert the key into the key

valve and turn the valve clockwise toward the OFF position

until it no longer rotates. Be sure the control knob is turned

fully off to avoid any gas leakage.

Fig. 9-2

ON OFF

Apply match - then turn on gas

Fig. 9-1