Owner`s manual

INSTALLING/REPLACING BATTERIES

CAUTION: ENSURE THE UNIT IS CONNECTED TO THE

GAS LINE AND HAS BEEN TESTED FOR

LEAKS BEFORE YOU INSERT BATTERIES.

REMOTE TRANSMITTER BATTERY

(remote models only)

To access the battery, slide open the lid found on the back

of the remote transmitter. Replace the old battery with a

new "12v" battery. Re-secure the lid.

REMOTE RECEIVER BATTERIES AND/OR

REMOTE RECEIVER BOX BATTERIES

(remote models only)

To access the batteries, locate the remote receiver box and

turn it over. The exposed "D" battery pack is for electronic

ignition. Replace the old batteries with (2) new "D" batteries.

(See Fig. 12-1.)

Slide open the lid on the remote receiver to expose the

batteries. Replace the old batteries with (4) new "AA"

batteries. (See Fig. 12-1.) Replace the lid.

SWITCH BOX BATTERIES

(remote models only)

To access the batteries, locate the switch box and turn it

over. The exposed "D" battery pack is for electronic ignition.

Replace the old batteries with (2) new "D" batteries. (See

Fig. 12-2.)

When battery replacement is complete; properly place the

(switch / remote receiver) box in the ﬁ replace as instructed

in the BURNER INSTALLATION section of this manual.

Important: Low/dead batteries will affect burner

system operation. Replace batteries any

time the burner will not turn on.

"D" batteries

Fig. 12-1 Remote receiver box batteries

"AA" batteries

"D" batteries

Fig. 12-2 Switch box batteries