Owner`s manual

FOR YOUR SAFETY, READ BEFORE LIGHTING

WARNING: If you do not follow these instructions exactly, a ﬁ re or explosion may result, causing

property damage, personal injury, or loss of life.

Do not use this appliance if any part has been underwater. Immediately call for a qualiﬁ ed professional

service technician to inspect the appliance and to replace any part of the control system and any gas control

that has been underwater.

BEFORE LIGHTING, smell all around the burner area for gas. Be sure to smell next to the ﬂ oor, as some

gas is heavier than air and will settle on the ﬂ oor. IF YOU SMELL GAS, FOLLOW THE INSTRUCTIONS

ON PG. 1.

Fig. 17-1 ON/OFF switch

1. Turn off any electrical appliance.

2. Press the "I" (Ignite) switch on the front of the switch

box. This transmits a rapid series of sparks at the pilot

head and will ignite the gas.

Sparks cease when the pilot ﬂ ame is lit and stable. After a

short time, the pilot will then light the main burner.

CAUTION: IF THE BURNER DOES NOT IGNITE WITHIN

20 SECONDS, TURN OFF, WAIT 5 MINUTES,

THEN REPEAT STEPS 1. AND 2. ABOVE.

If the pilot will not stay lit after several tries, turn the switch

box to "O" (OFF) and contact a qualiﬁ ed professional service

technician or gas supplier.

PILOT APPEARANCE

Periodically check the pilot for proper ﬂ ame pattern. The

pilot ﬂ ame should encircle the generator tip, and is preset

at the factory (see Fig. 17-2).

If the pilot ﬂ ame burns incorrectly; shut down completely

and contact a qualiﬁ ed professional service technician.

SHUTTING DOWN

1. Simply press the "O" (OFF) switch on the front of the

switch box. The gas ﬂ ow will cease, and all the ﬂ ames

(main burner and pilot) will go out.

LIGHTING INSTRUCTIONS - MANUAL MODEL

Fig. 17-2 Proper pilot ﬂ ame